Cannot connet to internet

use the wrt310n router as the router for the internet (where dsl modem is connected) then just connect the ethernet port (not wan port or internet port) of the SMC to the ethernet port of wrt310n

Make sure you are plugging the SMC into the WAN port on the Linksys router and not the LAN ports.  Your internet connection (which is your SMC) should always plug into your WAN port on the Linksys.  Any computers that you may need to plug in, like Desktops that are "wired" and not "wireless", should plug into the LAN ports on the Linksys.  If you are not using the WAN port on the Linksys for your SMC modem, then that would explain why you cannot get to the internet on wireless or wired computers.
Here's why you are getting the "low connectivity" message:

Computers don't understand why the Internet is connecting or not connecting...so the "low connectivity" message you keep receiving has nothing to do with your wireless signal strength.   To a computer NIC, "low connectivity" means your network adapter could not find a DHCP server and receive a valid IP address.  When this happens, your network adapter assigns an IP address to your computer in the following range...169.254.0.0, and will display the "low connectivity" message until it is able to receive a valid private IP address from the DHCP server.  You can verify this by going to START | RUN and typing "cmd" (without the quotes), then hit ENTER.  A black box will pop up....then type "ipconfig" (without the quotes) and hit ENTER.  This will show you your IP address, subnet mask, and gateway address, and you can verify that your IP address is in the 169.254.0.0 range.  A valid private IP address is typically in the 192.168.0.0 range, but could also be in the 10.0.0.0 range, or the 172.16.31.0 range.    Also, make sure you have DHCP server enabled on the Linksys router for the LAN.  This will ensure your "wired" and "wireless" computers receive a valid IP address.  
The WAN port on your Linksys router should be configured to "Obtain an IP address automatically using DHCP".

Cheers!

Just followw the link and you can get the driver you need.

http://www.smc.com/index.cfm?event=viewProduct&cid=1&scid=4&localeCode=EN%5FUSA&pid=544

re-configure the router properly and get the right details from your isp.(internet service provider)

just hardwired a computer to the router and open a web browser. on the address bar of the web browser type http://192.168.2.1 (default ip address of the router) and you will be prompted with the login screen. by default you don't need to type anything on the password field. now you will prompted with the router's page and from there you can set it up.
click here for the manual.

hope this'll help you

ciao

You need to open the port that Utorrent is using check this link for the step by step way on how to do that on the utorrent and on the router http://portforward.com/english/routers/port_forwarding/SMC/WBR14T-G/Utorrent.htm

Hope that helps..............

ok you do the reconfigure the linksys routerand give the wireless enable in the both smc and the linksys also .

Hy - How far have you gotten and what seems to be the problem? Thanks.

Jeff

hi fuf12, what configuration key are you looking for. If you are more specific, i can help you with your question.

I assume they told you to uninstall the software, remove the adapter, then re install driver an re insert adapter, as this normally cures the driver fault. If they didn't try that, if the problem persists the adapter may be faulty although i think it's a software problem. Try not to use Windows to repair connection as it never works and resets your pc's ip address differently than your routers already given it.