How to wire a 48000 colman - Heating & Cooling

To restart your Colman Tempstar furnace, first make sure the power switch is in the "On" position. Then press and hold the reset button on the furnace for about 10 seconds to reset the system. After resetting, the furnace should start operating normally.

may be a bad run capacitor need to check it if not you will need a hard start kit.

There are many streets around the world named Colman Street. When you ask a question like this on the World Wide Web, you need to be a little more specific.

The 48 before the VKD in the model number stands for 48000, BTU. For refrigeration, 1 Ton = 12000 BTU. Therefore 48000 BTU / 12000 (1 Ton) = 4 Tons

Hello The B wire now goes to the O termnal on new thermostat.

i got a new fitting solderd on in place of the dumb one colman had
$30 now it fits a normal fitting

check the main wiring harness area.
rodents get in and chew the wiring.

I have three colman coolers with broken hinges. I would like to find some new hinges to replace them . model # 6270 6273

look on your burner control relay - look for terminals marked T and TH.  connect up a honeywell thermostat here.