Question about Sony FD Trinitron WEGA KV-36FS120 36" TV

1 Answer

TV wont turn on, led flashes 7 times and repeats

When power the tv, a popping sound is heard from the speaker. The tv led flashes 7 times. Once in a while, after the popping sound is heard and the power button is pressed, the tv works fine unit we turn tv off and try turning it back on again.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 144 Answers

Hello,
Regarding your Sony FD Trinitron WEGA KV-36FS120 36" TV, according to the Offical User's Manual for this TV, it looks like you'll need to make a call to Sony's toll-free Customer Information Center.

In the Troubleshooting section of the manual, the only scenario it it gives for a flashing LED is the following.

From page 43 of manual.
PROBLEM: There was a blackout or power outage, and now the TV won't turn on and the timer LED is flashing.
SOLUTION: Press the POWER button on your remote control or in the TV front panel. If the problem persists, see "Contacting Sony" at the end of this section.

Page 45 of manual:
Before calling the Customer Information Center, reset the TV to factory setting (see page 17). Please have your TV serial number ready. The number is located on the rear of your TV and on the front cover of this manual.
Our Customer Information Service Center phone number is 1-800-222-SONY (7669) (US Residents only) or 1-877-899-SONY (7669) (Canadian Residents only).

Straight from the official SONY web site, here is a easily clickable link to the manual in PDF form.
http://www.docs.sony.com/release/KV32FS120-36FS120rev.pdf

I hope this helps you!
Sincerely, CBR2009

Posted on Aug 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I check the led light strips on my led lcd tv, to see if they work? and/or how do I replace the led light strips?


Contact any service technician. It will be best in this case. If you're sound in electronics, and have some previous knowledge in servicing LCD TVs; please respond. Otherwise please !!!!!!!!. Time is precious for us.

Jan 18, 2015 | RCA Televison & Video

3 Answers

TV power loss


most likely the part inside the tv has gone bad as you said that you heard a pop and this lead to take the tv to a technician.

Apr 29, 2008 | Televison & Video

1 Answer

I have a tv Sony Trinitron XBR. It does not turn on; the LED red light blinks 7 times.


Common problem on those. It has deflection stopped. I.C. on deflection board. Need shop to repair.

Nov 23, 2014 | Sony FD Trinitron WEGA KV-34XBR800 34" TV

2 Answers

I have an aquios LC-42D64U which suddenly has the following two lights blinking power & OPC. They both blink, once together, the second blink is only the power, and repeating the sequence. I've...


Sharp LED/LCD EEP cleared Step 1 Remove Mains Plug 2 Press On/Off Switch from LED/LCD Panel 3 Press Ch Down & Input Switch together and plug in mains cord 4 LED/LCD will start 5 "K" will appier on Screen 6 Press Ch Down & Vol Down from LED/LED Panel 7 1/9 Page will appier on Screen 8 Go to 9/10 page by pressing Up & Down arrow of remote 9 Select EEP Cleared 10 Press ok button from remote 11 On Screen dispay EEP running 12 Remove Mains Plug after complete EEP Run 13 Restart LED/LCD

Feb 05, 2011 | Sharp Aquos LC-46D62U 46 in. LCD HDTV

1 Answer

No Picture, Power light Blinking 3 times then repeats


3 times blink shows lamp cover is removed or not installed properly on TV.
Please take out lamp inside TV and check, seems its broken as you heard loud pop.
Thanks.

Aug 28, 2009 | Sony Grand WEGA KDF-55WF655 36" Rear...

1 Answer

TV acts like it is turning on then shuts off then repeat, repeat


When my lamp died the bulb literally exploded. That may be what you heard. Have you check the lamp? If the lamp is ok, the lamp's ballast or power supply might have blown.

May 22, 2009 | Toshiba 62HM95 62" DLP HDTV

1 Answer

Led lights flashing


replace the lamp. the lamps basicly have 3000 hours before they go, and also depends on the number of times the unit is turned on and off which greatly lessens the life of the lamp.

Feb 26, 2008 | Toshiba 46HM95 46" HDTV

2 Answers

50 inch 1999 TheatreView Television


#1 When I turn on the TV the power button comes on then blinks 6 times then goes off for a few seconds then repeats the cycle. I have sound over my surround system during this time but no picture.
#2 My sound would crackle and pop every once and a while until now it does nothing. I have to watch it with the surround sound on.

Nov 26, 2007 | RCA HD52W59 HDTV Projection Television

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-36FS120 36" TV Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

kakima

Level 3 Expert

102366 Answers

The Knight
The Knight

Level 3 Expert

74459 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...