Have a Kenmore microwave model **********0 the fan keeps blowing when the door is open and the table continues to turn.

The door switch is adjustable. one or more need adjusting to solve the problem

http://www.ebay.co.uk/sch/i.html?_odkw=kenmore+microwave&_osacat=0&_from=R40&_trksid=p2045573.m570.l1313.TR0.TRC0.H0.Xkenmore+microwave+motor&_nkw=kenmore+microwave+motor&_sacat=0

Hi,
One of the three door switches has failed and will need to be replaced. You would need to access behind the control panel to check them and or replace it. Good luck

I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

Check those 3 micro switches in the door latch assembly. A bad microswitch can blow the main fuse. This usually ruins the microswitch.

replace fan switch

It is one of two things, a defective door switch, or the keypad control board has failed.

This just started happening on my Kenmore microwave because the door latch broke off.

Hi, I am not sure of the cost concerning the control board, however, it does sound like a control board problem, or a door switch problem, I would need to see the specific unit diagram to know for sure, but many microwaves, not all, but many, have a door switch related to that part of the circuit, usually the fuse would blow at that point, but there again, it depends on the circuit. I would suggest you get the unit checked soon however. Hope that helps somewhat, and thank you.

This is usually caused by either a bad door switch, a loose door switch mount, or a problem on the control panel.

Even though a door switch clicks, it may still be bad inside. Its continuity must be checked.

Switch or mount trouble can be caused by slamming the door or by opening the door while it's cooking without hitting the Stop pad first.

If you someone you know decide to look into it, we have critical information on safety, disassembly and door switches at our site, and our link is at our listing here on FixYa: http://tinyurl.com/yzjozk

You can probably find an exploded view by entering your FULL model number here: http://www.searspartsdirect.com

A full Sears/Kenmore model number usually has 3 digits, a dot, then 8 more digits, such as ###.########

If you think the problem is on the control panel, which we repair these nationwide for $39.95 postpaid.

We're happy to help and we appreciate your thoughtful rating of our answer.

It could be a problem with your cooling fan or hood fan not venting the cavity enough.

To help you most effectively, it's better to post your full actual model number. But I'll give you the general info for now.

If this is a countertop model, you should feel strong air flow coming out from the back.

If it's an over the range model, you should hear the internal fan blowing when you hit Start and see the steam moving around while it's heating.

If the fan is not blowing and air is not blowing or if the next system is not working or blocked, you will get more steam than usual and the magnetron will likely end up being damaged.

Some steam buildup inside is normal, but not too much. It's kind of subjective, but it's dependent to a lagre degree on that air flow.

Most newer models don't have any gaskets to worry about, but older models may have deteriorated gaskets which limit the air flow.

Please write back with more details if you need further help.

We're happy to help and we appreciate your thoughtful rating of our answer once we pose a final solution.