Ade accentua 6remote keypad shows spanner light but it will not allow for set or reset

Found a solution to reset a maintance reminder and spanner light for G10 people mover. May work on a van model.

1) Make sure driver door is opened while perform the reset
2) Press engine start button to ignition but don't start the engine.
3) Press Set/Clr button to get rid of door open warning and service vehicle reminder
4) Turn the scroll switch downward to digital speedo, which is a page before distance to service.
5) Rotate scroll switch to down position 1 more to distance to service page and hold the scroll switch
6) Rapid press Set/Clr button 5 times within 3 seconds.
7}) Distance to service change from 0km to 8000km and spanner light go off instantly.

That seems to be an indicator that your wheels (tires) should be rotated.

Your manual indicates the reset procedure for these service lights.

Below there is a video that depicts a 2006 being operated.

Hope this helps.

Nissan Murano Service Light Reset Guide

Engine coolant temp sensor 2
or wiring fault ECT on the radiator. Check wiring and sensor around area. also try a battery disconnect for 30 mins at allow engine management system to reset. ensure battery is fully charged

you may have to use a scanner to reset the CPU for this unless there is something in the owners hand book on how to reset after a service.

Place the key into the #2 position (do not start engine). With the oil remaining light showing on the odometer, press and hold reset post for 10 seconds until it starts blinking, then let go. Press it again for 5 seconds and it should reset back to 100%.

your due a service in 200 miles......

I just checked on that one, they said to disconnect the battery for 5 minutes, and the lights will reset? I have heard this but never had to try it. Your spanner is scheduled maint and the oil light you know. And they both should be resettable. Hope this helps.

It is really easy, and requires no tools. There is a flush panel inside the car behind the lights, using fingernails pry it off, then all the bulbs are visible and quickly changed out.

there is a lug on top of the tensioner, allowing you to place a 16 mm open ended spanner on it, pull the spanner towards the front of the car to release the belt tension. There is a small hole in the lug. this will line up with another hole, and allow you to insert a pin (or a drill bit or allen key) through both holes, and thus lock the tensioner in its released state. the belt can then be slipped off the pulleys. good luck.

not sure what you mean by reset josh

I don't know about the remote hand held key problem but concerning the light staying on...Try... turning off the rear dome light by pushing up on the fixture... it may have been accidently activated when loading stuff in the rear.

The rear dome light has a option feature that allows you to turn on/off interior lighting while loading cargo at night.

Good luck