An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: Drum light on HL2030 won´t go off!
Open the front door, and press the go button until the lights flash, after closing, press the go button 3 times for a printout showing the drum as full again. The instructions come with the new drum...
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
? 2:25 www.youtube.com/watch?v=t4GGvm3aW7c Oct 25, 2012 - Uploaded by nobblynoel
Brother HL 2040 Printer Repair solution for multiple page jams For more Info ... My Brother HL2030 laser printer is making a groaning/grinding noise on ..... FIX YOUR PRINTER: ERROR: Printer Does not Grab Paper fromTray ...
i looked at the service manuals, there is not one for the hl-2030, however for the hl-2040 is indicates that the front cover or back cover door is open, check the back door and see if the sensor is moving freely.
Hi from what i have read on the internet and past experience with these printers (our company has 20 -30 of them) the fault is within the printer and requires a service call from brother.
if its still under warrenty i would suggest taking it back for a replacement if that is not possible but its still under warranty ring up brother in your country and get them to send out an engineer. we have just had another one of our printers start doing this after some routine maintance (we simply used compressed air cans to clean out any "rubbish where the toner / drum assembly goes) after that the printer is now flashing all 4 lights.
sorry i cannot be more positive about the problem but as mentioned its a fault within the printer that requires an engineer.
Have you already replaced the drum? If you have not replaced the drum that may be why you are getting smudges. If you have already replaced the drum, here is the reset procedure.
The Drum LED blinks if the drum unit is near the end of its life. Use the drum unit until you have a print quality problem, then replace the drum unit with a new one.
The Drum LED continues to blink if the drum counter was not reset when you replaced the drum. To reset the drum follow the instructions below:
Open the front cover of the printer.
Press and hold down Go button for about 4 seconds until al the LEDs light up. Once all 4 LEDs are lit, release the Go button.
Close the front cover.
CautionReset the drum counter only when you replaced the drum unit with a new one.Related Models
HL-2030, HL-2030R, HL-2040, HL-2040R, HL-2070N, HL-2070NR