Fagor w/dryer,F04 on panel 'door not shut properly' a gentle nudge has been working,but extra hard nudges last night blew fuse & lights on control panel. Changed fuse but not working,is this fixable?

bad door switch or washer door is not being shut fully

people who specialize in nudge bars and bull bars are manufacturers lie TJM and ARB so contact them for further information

Plastic lead inside front of soap dispenser unlocks door.
Remove front panel, undo top panel & lift up, check wax motor (red / brown unit above / top of door), usually burnt out taking control board with it. If you are going to repair fit 5 amp fuse in line with wax motor or fit later model door lock mechanism.

Usually, the lenswork's taken in a grain of sand or been accidentally muscled sideways (or gently touched by a vibration in a large stone, as it were.) So you have to find the right moment to nudge the lens back into the proper tracks or knock the sand out. Stripping and reassembling it is an effective but hard way compared to patience and sighting the sand. Plus if you get 30 grains out, you get a laugh.

Hi from retired Englishman in SW France,
There is likely to be a problem with the 'door closed' sensor, unfortunately requiring a service engineer's attention I suggest ;-0(
Good luck,
John C

You have a broken belt.

it's the motor to weak to jurn over,i see it all the time,replace the motor if you want(ebay)the model number is inside the door-mike

Check the track to make sure there isn't anything obstucting it. This might sound obvious, but you never know.

A quarter was lodged on the thermal fuse , located below the lint screen on the blower exhaust housing, on our dryer. Remove the front lower panel , 2 screw, and you'll see 2 fuses. I suspect that our control board is burnt.