Question about Standard (CRT) Televisions

1 Answer

Re: tv switching on and off.Model Thomson 28DG22E

The power bulb on the front flickers between orange and red whenever we switch on the dvd player or cable decoder. We get no picture or sound.
This has happened before, approx a year ago. and it started working normally again. The problem seemed to have cleared itself. But now we are back to square one.
Can you please help.?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers
Re: Re: tv switching on and off.Model Thomson 28DG22E

You must have the tv on standby, that is why when you try to switch on decoder/dvd player.
Most common fault on a Thomson tv would be dry joints (bad soldering) mainly around hot and high voltage parts, eg transformers and high voltage transistors.
Unless you are into electronics field, know the safety procedures and have good soldering iron, take to a repair shop.


Posted on Nov 30, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer


Connect the composite video RCA (yellow) cable output of the DVD player to the TV's video input RCA (yellow jack). Connect the red and white RCA cable from the DVD players audio output to the TV's audio input (red and white jacks). Select the source input from the TV's control panel - if it has an input selector switch, set it to select the video source from the front panel input jacks if you connected the three cables - yellow, red and white on the front of the set. Or, change the channel to receive the video auxiliary input source instead of the broadcast station.

Dec 20, 2010 | Durabrand DWT1304 13" TV

2 Answers

I have 54 tv telefunken model No. MR701, ineed to now the posion No. of the capacitor CP50

My MR701 Telefunken TV set does not want to switch on with its remote control.When I switch of the plus nad then on again. It switches on and a sign with the key and wording MENU appears after few seconds it switches off again.Some times it does swtch on with a universal remote. The red light where the sensor is keeps on lickering when its on standby.Under normal circumstances it stays red without flickering when the TV set is
on standby. Please help.

Feb 22, 2009 | Curtis-Mathis CM25011 25" TV

1 Answer

My THOMPSON TV won't turn on!!

Circuit board inside the TV was loose!!

Feb 16, 2009 | Thomson 24WK25U 24" TV

1 Answer

Sony Trinitron Colour TV Stopped showing and switch light flicker

The vertical output IC has failed/Power to the vertical IC is out/ or there is bad solder on the pins of the vertical output IC.

Dec 01, 2008 | Sony FD Trinitron WEGA KV-34HS420 34" TV

3 Answers

Lightning mcqueen tv and dvd set-up, won't play, have direct tv hook-up

i guess there a built in dvd player on the set and it could play most DVD format.
but if you wish to use another dvd player
hook up the dvd on the tv
video output (DVD) to video input (TV)
audio output to audio input
the find the auxiliary button from either the tv or dvd

Oct 30, 2008 | Disney DTD1363-CAR 13" TV/DVD

1 Answer

We have thomson tv 32" color crt sort length model 29df45 c s /icc20

tv power goes off when vcd / dish receiver is connected

Aug 12, 2008 | Thomson 29DM400 29" TV

1 Answer

Tv stuck in standby

Your problem is in the switch mode power supply or the horizontal out circut.
sometimes the small CHOKE that feeds the base of the horz. out transistor has a cold solder joint.
resolder both ends first.
Thanks Guy9

Jun 10, 2008 | Standard (CRT) Televisions

1 Answer

Thomson 44jw611s rear projection tv

hi there, red light flashing means a shorted parts on the unit, do some test, check the horizontal sec, check the FBT if ok else buy a new one. ty

Feb 12, 2008 | Thomson 28VK25US TV

1 Answer

Magnavox hd2504

try turning the dvd player on,and
inserting a dvd,and then switching
to video the tv has to have a silgnal
when you switch to video the dvd
players splash screen should come
up,and then it will load the dvd

Nov 21, 2007 | Sanyo DS25390 TV

Not finding what you are looking for?
Standard (CRT) Televisions Logo

Related Topics:

310 people viewed this question

Ask a Question

Usually answered in minutes!

Top Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66604 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides