Bauknecht Dishwashers stop working after several minutes and I there are three Beeps. the letter H on the screen.

The timer is not advancing to the next cycle. Replace the timer.

Need a new timer.

Please check on the link below:

http://www.bauknecht.co.uk/

Set the machine to the end of the drying cycle, when it has finished, try pouring boiling water into the machine about a kettle full there is a sump level control beneath the removable filter (where all the **** gathers) if this has fat deposits on it this type of problem can occur.

Most likely the heating element or a thermostat.

have got a bauknecht gsx4756 which when started beeps continually and start light flashes. it automaticaly then flashes the rinse button as well. I have reset holding down start and mode selection button next to the start button the fault keeps recurring. just wanting to know what the problem is before paying an engineers extortionate call out fees

The F7 means that the drain filter is blocked or your water pressure is low. Check and clean filters. Good luck !

I have this problem frequetly - it's an easy one to fix! Just press the programme button which changes the programme setting you want (on my built-in GSX4756 it's the last button on the right) and keep it pressed in until the beeping stops. Then start it again (will probably be on the rinse programme if it's like mine).