Has a double safety i broke the top one, i need to discharge the bow the safety below release any suggestion?

Pull back on the Bow string until all pressure is off the safety switch then pull trigger and slowly let the string release without letting it fire

These tools can be DANGEROUS!
If you don't know how to release a safety catch, I sincerely suggest that you:
- UNPLUG THE SAW,
- READ THE MANUAL
- FAMILIARIZE YOURSELF WITH EVERY ASPECT OF THE SAW
- READ THE MANUAL AGAIN
- DOUBLE CHECK HOW THE FUNCTIONS WORK
and then,
Plug it back in, and
CAREFULLY
start to try the different functions.
IF YOU ARE UNSURE
GET SOME ASSISTANCE
FROM
SOMEONE WITH KNOWLEDGE AND EXPERIENCE
SINCERELY

If your top is electric then you will need to release the front cowl motors at the center point of the trim in front of the rear view mirror(small access plug needs to be removed and allen key inserted to drive unit.) You also need to pull the release handle under the back seat bottom(driver's side) The release handle detaches the drive units for the storage lid cover and the convertible top drive. Once the motors are released, the front of the top must be lifted approximately 6 inches and the pressure against the rear of the top will relax. raise the rear bow, open the storage lid, lower the rear bow and push the front of the top up and toward the back of the car. The top should fold into the storage area. Once in, close the storage lid until it clicks.

arrow has to be in it and you push forward on the safty.

you have a conv. bad chips

Hi, thank you for visit fix ya.
Resolder all connections around fly back ( check for open pico fuse).
if still problem, replace convergence board.
Thank you

One or more colors can't be adjusted when when using the convergence menu. Screen is bowed in but stationary.

Solution: 

You need to replace the convergence chips and convergence resistors. Check the site www.TvRepairKits.com. They have put together a kit for your exact model. The kit inlcludes a photo instruction guide, original Sanyo STK chips, convergence resistors, etc. Everything you need to fix it yourself. Its an easy fix. 

Double check your work for errors such as solder bridges or incorrect resistor placement. Look carefully anywhere solder could have dripped or splattered to cause the bowing. If you entered the digital convergence mode to touch it up, you will have to re initialize the magic focus for it to function. Good luck

bad convergence ic's
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html