Eo error message - Kitchen Ranges

An EO error indicates an electronic error caused by either a control board problem or a problem with supply voltage to the heater. A single EO code is not cause for concern, but for repeated EO codes

Hello Gary, I am happy to assist you! I see that your Frigidaire dishwasher is displaying error code EO; however, is it possible that the code is missing a number or character(s)? Typically error code "E0" is follow by another number. In the meantime, you can reset your dishwasher. This can be done by either unplugging it or flipping the household circuit breaker off. It is important to wait approximately ten minutes and then turn on your appliance. If resetting the power does not correct the issue, could you please advise me of the new error code or if it continues to display "EO"? With this information I can better address the issue at hand. Thank you! - Z

You need to put the RED SAFETY KEY on the Yellow spot on the control panel to turn it on. EO will disappear once you put it on.

Paul

you may have an oven temp sensor out of wack. may have carbon on it . wires going to it may have burned

Hi I have the same fault did you fix

turn the circuit breaker off for about 15 mins. turn it back on and it might reset itself. let me know if it works!!!

model790.9503 gives f31 code

What is the error message or code that you are getting?

that fault refers to a shorted key panel, recommended repair is to replace replace Electronic Range Control/Clock (erc)

Actual Solution: I justed fixed EO F2

1. Disconnect the power for 30 minutes!
2. Once reconnect the power, press the "cancel" button for 3-4 sec, this two steps serve as reset.

I have a Whirlpoor gas range and it has error message EO F2 for few weeks now. After searching on internet for possible solutions and didnt find anything working, I called Whirlpool thinking as a last attempt before calling expensive tech. people.

They told me exactly the above two steps, I came home and tried, it worked like a charm....

Note: Disconnect for 30 min, I tired 1 minute as some suggested on internet and didnt work.