Question about Kodak EASYSHARE 5100 All-In-One Printer

1 Answer

My printer says it's missing the printhead,just

My printer says it's missing the printhead,just installed ink

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 295 Answers

Go to kodak.com/go/printheadsupport and see how to remove printhead. again install it into the carriage. and then install cartridges .sometimes what happens is printhead gets loose. it will resolve the issue . let me know if it doesnt. tc

Posted on Jul 29, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 96 Answers

SOURCE: Error message: Printhead missing, not installed correctly or has come loose

Ok...very good. If you have problems in the future, send me a message. Kodak Products are my specialty.

Posted on Jul 18, 2008

  • 96 Answers

SOURCE: kodak all in one printer instalation error codes

Unfortunately, the only way to possible fix this error is to get the printhead out and reseat it. You can do that by removing the ink cartridges. Right above where the black ink cartridge was, at the top left hand corner of the printhead, if you push up towards the ceiling there should be a button that releases the printhead. You should now be able to tilt the printhead forward and pull it out of the printer. Reseat the printhead by putting it back in the printer and pushing straight back on the back wall of the printhead. It should snap into place. Replace the ink cartridges and close the printer. If the error clears, download the newest firmware from kodak.com so this never happens again.

If these steps do not clear the error however, call Kodak AiO tech support at 1800 421 6699 to get a new printhead.

Posted on Jul 21, 2008

  • 103 Answers

SOURCE: The screen says : Printhead missing, not installed

Printhead is faulty > Needs to be replaced

call kodak aio support and get a free printhead replaced

Posted on Mar 01, 2010

  • 1 Answer

SOURCE: print head missing, not installed

error 3806 came up i have carried out everything they have told me to do switch power off then back on after 30sec, re installed printer head twice, still 3806 comes up before calibration starts its got worse rather than better, what else is there i can do ?

Posted on Aug 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why will my printer not print. shows error 3802. just prints blank page. do have ink.


Error: "Printhead Failure" (105-3802) - Kodak

support.en.kodak.com/.../error%3A-printhead-failure-(105-3802)

KodakAug 25, 2010 - How do I resolve the error message "Printhead Failure" (error code ...If you are not prompted to calibrate the printhead, turn off the printer, wait ...

Error: "Printhead is missing, not installed correctly, or has ...

support.en.kodak.com/.../error%3A-printhead-is-missing,-not-inst...

KodakAug 25, 2010 - How do I resolve the error message "Printhead is missing, not installed correctly, or has come loose" (error code 105-3513) on my ESP or HERO All-in-OnePrinter? ... If the printhead and ink cartridges are not installed in the printer, install them: ... If the error continues, restart the printer and try to print.

Jan 18, 2016 | Kodak ESP5 AllInOne InkJet Printer

1 Answer

Printhead Loose or missing. Install printhead or ink cartridges.


THE PRINT HEAD is the LASER that puts the image on the drum which puts the image on the transfer belt then paper or the drum puts on the paper. Missing the Print Head !!!!!!!!!!!!!!!!!!!! did you get it second hand? Not something you can get at a store. Contact the company and see about it being repaired.

Nov 15, 2015 | Kodak Esp 2150se Wireless Office...

1 Answer

Error message Printhead Missing or not installed correctly


The printhead is the device in which the ink cartridges sit. It may be mis-installed.
Take out the ink cartridges (carefully, you can get ink on yourself). Now using the gray latch on the right side of the carriage, remove and re-install the printhead. Jiggle it a little before lowering the latch to seat it.

Now, re-install the ink cartridges.

See if it works

Feb 26, 2011 | Kodak ESP 5 Printer

1 Answer

I've turned on my printer and it says " Error" "


Go to the Kodak site
Visit the page to download latest firmware
Install firmware

Jan 14, 2011 | Kodak Office Equipment & Supplies

1 Answer

Just installed new ink cartridge , now getting error message saying ,printhead missing,or not installed right. whats going on.


Call Kodak @1800 421 6699 and get a new printhead free of cost.....Printhead has gone bad and it is the part in which we install the ink cartridges.It takes the ink out of the cartridges and spit the ink on the papers,...Cheers and Enjoy.

Dec 28, 2009 | Kodak ESP 5 Printer

2 Answers

I have a kodak 5500 aio printer. I replaced the


Try the following:

1. Open the printer access door.
2. Put out both ink cartridges and the printhead.
3. Let the printer access door open.
4. Put out all paper.
5. Pull out the ac adapter at the back of the printer.
6. Wait 60 sec.
7. Pull in AC adapter.
8. Wait 30 sec. then turn on the printer
9: Wait for the error message: Printer access door open.
10. Close the printer access door.
11. Wait for the error message: Printhead is missing.
12. Open the access door and put in only the printhead and the close the access door.
13. Wait for the error message: both ink cartridges are missing.
14. Open access door, put in only the black ink cartridge, then close the acess door.
15. Wait for the error message: Color ink cartridge is missing.
16. Open access door, put in the color ink cartridge and then close the access door.

If the error is solved, do a firmwareupdate right now.

You can find it here.

Sep 22, 2009 | Kodak EASYSHARE 5500 All-In-One InkJet...

1 Answer

Error message re printhead.


To resolve the error condition:
  1. Open the printer access door.
  2. Remove the color and black ink cartridges.
  3. Remove, then reinstall the printhead
To reinstall printhead follow the link.
http://www.kodak.com/global/plugins/acrobat/en/service/manuals/AiOPrinters/printhead/AUR1780-9_UE_RevC.pdf


Nov 15, 2008 | Kodak EASYSHARE 5500 All-In-One InkJet...

3 Answers

Error message: Printhead missing, not installed correctly or has come loose


In regards to the error message with the printhead missing or come loose......I had that issue just shortly after I installed my printer. I was going crazy trying to fix it taking it out and reinstalling which was a pain, removing the cartridges and then the printhead to no avail. Finally I got smart and disconnected the power cord from the printer itself, not directly from the outlet. Once I did that and turned the printer back on the error was gone. It might have been a fluke, but it worked for me, so you might want to try it.

Jul 04, 2008 | Kodak EASYSHARE 5500 All-In-One InkJet...

2 Answers

5300 kodak eazyshare printer


Well, here is the proper way of fixing or troubleshooting that paper jam error in your printer

Open the printer access door and remove both of the ink cartridge, then remove also the printhead, after that close the printer access door, without those parts. Then it will show a message in the printer screen, "Printhead is missing or has come loose" or "Printhead Not Detected" Install the printhead, just the printhead without the ink cartridges. After that close the printer access door. Then it will show you a message"Ink cartridges is not installed,install ink cartridges". then open again the printer access door, then install the black ink cartridge without the color ink cartridge. then close the printer access door, then message must be " Color ink cartridge is not installed, install color ink cartridge" then install the color ink cartridge." the message must be,"New printhead is detected calibration require, load paper and press start"

Thats the way of overiding the paper jam error message of your kodak all in one printer
hope this will help you guys

by: E.brown

Happy Printing(", )
Kodak AIO tech support 1-800-421-6699

Jun 04, 2008 | Kodak EASYSHARE 5500 All-In-One InkJet...

Not finding what you are looking for?
Kodak EASYSHARE 5100 All-In-One Printer Logo

563 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kodak Office Equipment & Supplies Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18391 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Cindy Wells

Level 3 Expert

5102 Answers

Are you a Kodak Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...