Cannot find installation disc for my epson 3490

The Epson 3490 is a flatbed scanner that has an optional business card/4x6 photo auto feeder. Do you have the optional feeder attached & plugged into the correct connecter on the back of the scanner? Also, make sure the Epson scanning software has been configured to use the auto feeder. http://www.epson.com/cgi-bin/Store/ProductQuickSpec.jsp?BV_UseBVCookie=yes&oid=48059604&category=

Try Best Buy. You need a USB A to B Cable

I googled Epson support and found the answer. Here it is:
Macintosh Leopard Support Contact Support
Welcome to Macintosh OS X 10.5 Leopard support for Epson products. Here you can find out how to get drivers and other Epson software for your Epson product that work with Macintosh OS X 10.5.
Check your Epson product CD to see if it already contains Macintosh OS X 10.5 drivers. If the CD indicates support for Macintosh OS X 10.5, follow the instructions that came with your Epson product to install your drivers and other software.
If your CD does not list OS X 10.5 Leopard, follow the Step-by-Step Instructions below.
View our Macintosh OS X 10.5 Leopard FAQs.

look at the bottom part of the scanner. make sure that device LOCK at the bottom is UNLOCKED.

i am not sure if the two could be readily connect. but, you may connect them on two of the USB port on your PC at the same time.

If the start button light is flashing red, it is because of one of the following problems:

• The scanner is not connected to your computer properly or your software is not fully installed.
• The transportation lock is locked. Slide the lock to the unlock position.

After trying these solutions, unplug the scanner to turn it off, then plug it back in.

I just finished scanning many 110 film strips. You need to lay the strip along the inside edge of slot A and scan in normal preview mode. On the preview strip, put a marquee around each individual photo and scan each one separately. Worked fine for me.

If you are using epson scan to scan from your computer, please uncheck the thumbnail option.

Hi Dave!

Go to a good elecronic store and buy a power cord.
Juste be sure that you have the info about the cord you lost.
You will find that info here:
http://files.support.epson.com/pdf/pr349p/pr349ppg.pdf

Just make sure that the voltage and the amphere is correct.
Any good elecrtonic store have replacement cords stored.

Good luck to you

Nic

The new PC was Vista and the CD that came with the scanner completed loading a driver without complaint. However, a new driver was needed for Vista. After downloading the new driver from Epson, uninstalling the old driver and installing the new driver, it worked.