Question about Computers & Internet
Very very wrong to talk bad things about our president Zuma Jacob. we all must respect our President Zuma. No matter what is wrong or right. We all must respect him....no future
Pray for peace and stability and the eventual maturing of all branches of government. The hopes of a country are presented to a president. That is a difficult weight to carry.
Posted on Aug 09, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: John Q president cb
If by calibration, you are referring to the check if your antenna is tuned, below information may be of help.
S/RF/SWR/CAL SWITCH. When in the S/RF position, the meter swings
proportionally to the strength of the received signal. When transmitting,
the meter indicates relative RF output power.
When in the "CAL" position, the SWR meter can be calibrated by adjusting
the "SWR CAL" control to the "CAL" mark on the meter face.
When in the "SWR" position, the standing wave ratio is measured.
SWR METER. Measures standing wave ratio of the antenna system.
Used to properly adjust the length of the antenna and to monitor the
quality of the coaxial cable and all RF electrical connections. If there is any
degradation whatsoever in any of the foregoing, due to humidity, salt
spray, vibration or corrosion, the SWR meter reading will rise, thereby
indicating that a problem exists.
To calibrate, switch to the "CAL" position, transmit by pressing the mike
switch, and adjust the SWR control to the "CAL" mark on the meter; then
switch to "SWR" position for the SWR measurement.
If however you are referring to the internal calibration or tuning of the transmit and receive sections, you would need several instruments/equipment such as RF generator (0-30Mhz with 1Khx modulation), Spectrum Analyzer, Modulation Scope, Dummy Loaded Wattmeter, Frequency Meter and some others. These of course are not readily available to the average user.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
Posted on Jul 02, 2008
there is a little flange on the clasp that can be bent to make it snap tightly. Most jewelers will do this service for free while you wait.
Posted on Mar 22, 2009
Wow I've never seen a six wire Turner + 3 anyway give this a try 1)shield & blue 2) white 3) black 4) red if the radio keys up as soon as you plug in the mic switch black and red . Good luck . Dan
Posted on Jul 27, 2009
I know how to get to the cord but where do you get a replacement from?
To get to the cord, remove the round things on the side and unscrew the screw underneath.
Posted on Oct 22, 2009
Tips for a great answer:
Feb 05, 2018 | Government
Nov 21, 2017 | Garden
Jan 30, 2017 | Cars & Trucks
Jan 04, 2017 | Books
Sep 17, 2015 | Computers & Internet
Mar 01, 2015 | Computers & Internet
Jul 06, 2014 | Computers & Internet
Jun 21, 2014 | Computers & Internet
Mar 08, 2010 | Apple Secondary Language Arts and Social...
45 people viewed this question
Usually answered in minutes!