E29 Trouble Code for a Honda Generator

check outlets and wiring for corrosion or short

It would normally show that you are drawing more power than the generator can supply. Videos in the link

https://www.google.com/search?q=Honda+generator+EU65is+overload+indicator

..

• The Auto Throttle System switch needs to be in the off position.
• If the generator has not been used for awhile than the fuel is stale and the generator may be slow in responding to the load change. Replace fuel with fresh fuel.
• Attach a second load such as a 100 watt light bulb standard bulb with a tungsten filament. Observe the light as the heater cycles. If the light goes very dim than the generator is slow responding to a load change. Generator carburetor needs to be cleaned, tune-up. Run fresh fuel under load to see if carburetor will clean itself.
• Try adding choke to see if richer mixture reduces voltage dip. Check manual for mixture adjustments.

As silly as this sounds, Harbor freight toold generators by "Predator" will shut down if the generator is not on level ground, and the oil level is not at the desired level, crazy but there is an inbuilt oil level sensor. maybe this might be the answer. hope iy helps, good luck.

You can use Engine Oil of API - SF grade 20W40 & 15W40.

It is a inverter protection activation (e-22). Usually followed by e-20,e-10, e-04. Could be a short the inverter or the gcu.

it may be a thermal coupler that cuts out when it gets to hot i would let it cool off for a bit then try it with a lighter load and go from there

ARE SURE ITS THE OVERLOAD LIGHT AND NOT THE NOIL ALERT? IF ITS THE OIL ALERT ITS CAUSE YOUR LOW ON OIL OR THE SENSOR INSIDE THE GENERATER IS BAD?

Check the Ground Fault Indicator circuit breaker for triping, and look for the high limit on generator. Reset the main breaker by triping it full right and then back. Vitally

hi, i have a portable generator that has Nissan GX 1600 on it,who makes it? and do they have a web site?