I had wireless for some reason it has been disabled how do i enable the wireless adaptor

make sure wireless adaptor is on( done through control panel) or external air card is connected. scan for networks. Select your network log on w your password. May have to disable wired settings. May have to enable wireless adaptor. Can you give me any more info about it?

I’m happy to help further over the phone at https://www.6ya.com/expert/louis_03c793f49b118a83

First of all make sure your system and your iPhone connected to same wifi network. Try to disable and enable network adaptor of your PC using Device Manager, also disable and enable wi-fi connection after doing that Make sure you have enabled Wireless sync in your iPhone then restart the itunes.. Wait few seconds it will surely find out your iPhone.

If problem still persist let me know.

Looking forward to hear from you.

Thanks & Regards,
Chandrashekhar.

In Device manager, under the network adaptor are you able to see wireless adaptor for your device. - see if it not marked as disable( Red Mark or Yellow Mark)
Also check in network connection wheather you Wireless connection is in Enable or Disable mode,

Note: Please dont forgot to rate me.

Assuming you're in Windows, Hit the start button, right-click computer/my computer, hit manage.

This will bring you to the computer management console. Open the Device Manager from the left pane.

Expand the "Network Adapters" option listed. From here, you can enable/disable your Network Card or check for up to date drivers.

try going to network places try disabling and enabling the icon which is for your network connection.If its wireless try disabling/enabling that..try going to device manager from computer reight click and try uninstall/install the ethernet/wireless adaptor drivers.

I had to find the network adaptor in control panel then right click and Enable it. For some reason it was disabled. That's why it wouldn't power on.

Hi Houzeman Have you: re-started the computer         power-cycled the router, ie, unplugged unit and waited 10+ seconds, before re-connecting                 disabled the unit, then enabled it checked in Control Panel that the wireless card/ usb adaptor, is enabled; try disable/enable
before checking settings
re-input username and password
re-input security settings?

If you are using a separate modem and router, turn both off, then power-on the modem, before the router.  If you have ethernet access, and a Local Area Connection is available, use it to open a browser and type in 192.168.2.1 (assuming yours is a Belkin) and check your settings.
I use a Belkin, which is a good unit, but it can be cantankerous sometimes, dropping out, then coming back unexpectedly and without reason. Good luck NOEL

Hi , Do you have a wireless router ? Did you disable the wireless network , If yes you need to enable . You need to check if the wireless driver is installed properly for that you need to RightClick My Computer+Properties+ Hardware + Device Manager + Click On Network Adaptors . If Yes the n you need to Right Click My Network Places+ Properties and check for Wireless Status + Right Click Enable.

two suggestions, first you may need to enable it in your computers setup program. Normally you have the option just before windows starts to load, either by pressing F8 or esc will get you into the the computers main/basic setup screen. You should find the wi-fi is disabled so just a case of changing it to enable.

Secondly, within windows go to control panel then device manager, network adaptors, and you may find that your broadcom 802.11g network adaptor is disabled, you will need to enable it by using the icons at the top. If there is a problem with it then there will be a question mark beside it, then you will need to post the error message your getting for further assistance.

look on your taskbar for 2 little screens with a red ross, right click and click enable or go to start>connect to>show all connections, then right click on your wireless connection and click enable.