Question about GE JKP27 Electric Double Oven

1 Answer

GE digital Timer Oven

Buzzer goes off and F1 shows on the panel Cannot turn the timer buzzer off.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 213 Answers
Re: GE digital Timer Oven

Most of the time turning the breaker off for a few min will be a temp. solution but it it comes back then the ERC which is the clock itself needs to be replaced

Posted on Nov 22, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

How do i stop the buzzer on my neff oven. No timer is set but still dings.

Sometimes it is necessary to wiggle the time setting knob back and forth to get the buzzer to stop.

Jul 04, 2016 | Neff Ovens

1 Answer

How to use timer on simpson fabulous 400 oven

is there no stem to pull out and turn this oven search tells me it is over 40 years old .

Jan 24, 2015 | Ovens

1 Answer

Manual ge p7

You should be able to access the clock from the back panel. Make sure the power is off and you can disconnect the power to the clock motor. Tape off the wire to prevent it shorting out against the case. generally the white wire is the neutral and can be safely disconnected without affecting the clock operation of the oven. Some clocks also control the oven operation. Make sure that you are not disconnecting this feature.

Nov 04, 2013 | Ovens

1 Answer

F1 trouble signal going off, buzzer sounding constantly

the F1 code means that a button on the touch pad has shorted out,and thusly the touch pad needs to be replaced


Jul 24, 2011 | GE Profile JTP18 Electric Single Oven

1 Answer

It takes 28 minutes for the oven to reach temperature of 375 degrees. The ready buzzer goes off in about 15 minutes. The temperature is 300 degrees. Is there any adjustments to be made.

what is your oven if is gas or electric, if is gas easy to preheat by using lower heating element, if electric? that your unit have convection? or not? coz some probelm of the oven is, 1 if the oven is no convection or your oven is single heating in upper element,if your oven have a timer and cut off in 15minute? dont use timer,use a manual timer by it your self,if you want to reach the degrees that you want check your oven if der a lower and upper heating element with convection function,that the one is the most easy way to reach the degree that you want to reach.

Dec 17, 2010 | Ovens

3 Answers

Volume control candy oven timer

Switch off the oven, leave for 5 seconds and switch it back on.
Candy Customer Services asked for over £100 to have an engineer sent to my house, which I refuse as I thought the oiven was good.
I had to switch off all the electricity in the kitchen but after this 'reset' the oven turned to the normal 'high' volume.

Jan 12, 2010 | Candy Ovens

1 Answer

When the oven is turned on to preheat, the buzzer goes off and an "F1" error message is displayed and the oven turns off. The model # is MGR5750ADW. Is there something we can do to fix it?

An "F1" error code means you have a defective clock assembly (also called ERC- electronic range control). You will need to replace the clock assembly, and they are not cheap, around $200. Hope this helps you, good luck.

Oct 04, 2009 | Maytag Ovens

3 Answers

My kenmore electronic stove is having a beep with code F1 on the

Please use the chart to determine which stove you have. You will have to look at the model number. The first 3 numbers will be the series on the chart. In most cases an F1 error would require replacment of the electronic control. This part is commonly refered to as an EOC or ERC. However this type of repair is usually reserved for repair specialists.

KENMORE Range/Stove/Oven Fault Codes – 362 Series (General Electric)
F1 = Stuck Touch Pad Key - Replace Electronic Range Control (ERC).

KENMORE - 911 Series (General Electric/Roper)
F0-F1-FF = Failed transistor in Electronic Range Control (ERC).

KENMORE Range/Stove/Oven Fault Codes- 665 Series (Whirlpool)
F1-E0 EPROM Error - Electronic Range Control (ERC).
F1-E1 EPROM Error - Electronic Range Control (ERC).
F1-E2 U/L ERC Errors - Electronic Range Control (ERC).
F1-E3 Fuel Type Fail

Kill power 30 seconds-Cancel-Start/Enter-5 seconds-Should see “E” for electric-
“9” for gas-If code changes again-replace Electronic Range Control (ERC).

KENMORE - 790 Series Electronic Oven Control (Frigidaire)
F1 = Shorted Touch Pad = Electronic Range Control (EOC) Internal checksum error.
Runaway Temp = Replace Electronic Oven Control (EOC).

Kill power 30 seconds - if error returns - replace Electronic Oven Control (EOC).

Dec 15, 2008 | Kenmore 40494 / 40495 / 40499 Electric...

1 Answer

Whirlpool super capacity 465 timer won't beep

clock timer and motot for a black electric oven 220Volt. oven number on plate at bottom of door is these two RGE 1600 P 5.8 and MK 93877451 4.4


Jan 12, 2008 | Whirlpool GBS307PR Electric Single Oven

Not finding what you are looking for?
Ovens Logo

Related Topics:

274 people viewed this question

Ask a Question

Usually answered in minutes!

Top GE Ovens Experts

William Miller
William Miller

Level 3 Expert

8795 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers


Level 3 Expert

6993 Answers

Are you a GE Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides