How can I restore emachines EL1358G-51W? - eMachines Computers & Internet

The model number you gave did not include a monitor. Can you give details about the monitor itself like manufacturer and model number? Is the monitor an older style big and deep or an LCD panel style? The symptom you describe seems typical of some kind of electrical protection disconnecting power to the monitor same way as a circuit breaker in your house.

Can you try the restore with a different monitor?

The Two Thumb Screws above and below.

yes you can upgrade the graphics card, you have integrated graphics but you can purchase a PCI-E graphics card and bypass the on board graphics but keep in mind you'll have to buy a "low profile" graphics card as there's not much room in your case and a full size card will not fit.

Yes, I use them for a year, and then they sell them.

Is there a problem?

OH, C'MON I'M JUST KIDDING!

1) Is the computer dirty inside?

The two major issues with desktop computer failure, is the computer is dirty inside; and Power Supply failure.

Post back in a Comment. We'll start here.

Be prepared for a 'Windy' tech. You may do so much reading, you'll feel like you are back in school.

(I explain in detail, as if you know absolutely nothing about your computer. Just the way I ride )

Regards,
joecoolvette

You will have to reboot into safe mode to remove those drivers from the device manager and then reboot and allow windows to find the drivers it wants and not the drivers you think are the right ones because sometimes a flaky driver will stop windows cold and lock it into a loop forever.
If you do not know how to boot into safe mode, when you turn on your computer, the moment you see anything on your monitor start rapidly pressing the F8 key until you get a boot screen that has a choice of booting into safe mode, then follow the directions and when you finally get into windows go to the device manager, (in most windows will either be accessible from the control panel or from the control panel then clicking on system>then hardware tab>then device manager button.
Good luck!

Be sure to look on back of tower to see what power you need. The power plug needs to be 115v or 125v on most. Be sure your cord is the same voltage.

probably PSU is dead...

Try safe mode and use system restore.

Here you go [http://www.dl-provider.com/search/emachines%20el1358g%2051w%20manual%20.pdf.html?aff.id=1376]