SOURCE: see above
This is an older b&d stapler but the designs are similar in most cases. The position of the springs, and the order you put them in, are an obvious factor.
The parts that overlap go in after the parts underneath.
When you have one half assembeled you should not have to force the cover to go on, it should just sit in place while you put the screws back in.
If the handle coil spring and the flat spring are not seated properly the top cover will not go on easily.
These types of staplers are designed to clear from jamming without being taken apart, the staples, under normal circumstances, do not have access to the body of the unit past the flat spring.
As with any tool forcing the tool after a fault will only make matters worse, I would try some light oil or spray lubricant first before taking anything apart, these springs can be a pain to get back in, which is why I have not taken this one any further apart. Hope this helps you. If it does please let fixya know.
Regards
Les
SOURCE: i took apart my 66 powermaster bb gun and i cant
66
C66-OM
C66-EVP & PL 1 & 2
Powermaster. Pneumatic, BB repeater, .177 cal., single shot pellet. First variant w/zinc receiver.
1983-1988
Some parts are available.
66
C66-OM
C66-EVP
Powermaster. Pneumatic, BB repeater, .177 cal., single shot pellet. Plastic receiver.
1988-2001
Some parts are available.
66
C66CLIP-OM
C66CLIP-EVP
Powermaster. Pneumatic, BB repeater, .177 cal., single shot pellet. Plastic receiver and 5 shot manual clip.
2001-Present
Some parts are available
HERE IS MANUALS I FOUND..HOPE THIS HELPS..
SOURCE: How to put back together a smith & wesson air soft rifle
ooof i know how to put i back together and can teach you but its a doozi over the net. hows your experiance with airsoft internals also wat type of gun is it (spring gas aeg etc shotgun assault rifle pistol etc. email me @ [email protected] i can help you further with that info
SOURCE: honda big red 250 how to put back together
Go to the site below where you can see a parts diagram for your specific ATV. Being able to see the parts in secquence should help you to reassemble the motor. Get a new friend. You will select the actual brand, year, model, etc., once you go to the site. Part numbers and prices are also shown. You can order parts from this site. In the event no price is shown on a particular part and/or the notation "Not Available" is in the description, the part is not in stock. www.babbittsonline.com/pages/parts/viewbybrandand/parts.aspx
SOURCE: I can' get the glue stick out of the glue gun
No need for concern. Just leave it there and then the next time you use it push a new one in as needed.
I haven't met a glue gun yet where you can take out the last remnants of glue stick.
If you prefer to remove it try this:
take a paper clip and straighten it (any thin,metal object will work) Heat the glue gun,unplug it,and then heat the end of the paper clip with a lighter/candle.
Insert it into the end that you load from,sticking it into the glue stick. Wait a short time and then pull the paper clip out. The glue stick should come out with it.
I find it easier to leave the glue stick in as I said,but it's your choice.
A hot glue gun is a very useful tool for joining modelling
materials and even more substantial materials can be fixed together with it.
'Sticks' of solid glue are pushed into the back of the gun, the trigger is
pressed pushing the glue stick forward and molten glue comes out of the nozzle.
The glue is manufactured from thermoplastics.
3,710 views
Usually answered in minutes!
×