I need to remove the valve cover on a 2000 2.4 pontiac grand am

Here's a AutoZone repair guide on removing your valve cover gasket. Repair Guides Engine Mechanical Components Valve Covers AutoZone com

this is pretty straight forward.. I would clean the engine really well first.. If you have never done this... its always good to take some detailed pictures at every angle to make sure you can reconnect everything correctly... use labels to help,, http://pdfstream.manualsonline.com/a/ad72a1a4-98f2-453d-b880-a88864e3ffe0.pdf
Pontiac Car manuals
Pontiac Workshop Manuals

the last one I did was on the passenger side on top of the intake. it was covered with a flat plate that was held in place with 2 bolts I think. remove the plate and the PCV is under the cover. pull out valve there is a spring between the cover and the valve, make sure it is put back in place when re-assembling. it does not use a hose to control crankcase pressures.

Hey Chuck,here's a link showing you how to remove your valve cover. Repair Guides Engine Mechanical Rocker Arm valve Cover AutoZone com

replace little black pipe refill coolent to corect level and recheck for leaks

as much as i would like to help on this one i have never did this to a grand am never
messed with one i never cared for those cars but i did look up how to do it for you and found step by step instructions for you here http://www.ehow.com/how_4507842_replace-valve-cover-gasket-pontiac.html
sorry i cant be of any more help

mcdevito75 here, You"d need to move everything attached to the valve cover out of the way without disconnecting any hoses or wires, then you need the tools, a 1/4 inch drive ratchet set with long sockets and extensions. Chances are your valve cover is just a little loose from engine vibration. Let your local repair shop check it for you.

If I remember correctly this vehicle has a plastic plenum and the pcv valve is inside the plenum. Only time it is usually replaced is when the intake gasket needs replaced (and it will).

Remove the coil assy. then remove the valve cover bolts, remove the 10 mm bolts from the timing cover, if you look between the 2 cam gears you will see 3 bolts each side, remove them and the valve covers are off.

You'll find the PCV valve on the right side of the front valve cover. You'll need to remove the valve in order to troubleshoot it to determine if you need a replacement. To remove, pull the PCV valve out of the cover and detach the hose

Test the old PCV valve to determine if it needs replacing. Blow air through it in order to see if it is clogged. If it does not seem to ventilate, then you'll need to install a new valve.

Pop the new PCV valve into the spot of the old valve. With the correct part, it should snap right in. Take the hose and reattach it in order to complete the installation.