Question about Sanyo DS32920 32" TV

1 Answer

Horizontal lines Developes horizontal lines when turned on takes 5 to 15 mintues to get full pic

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: Horizontal lines - Sanyo DS32920 32" TV Standard (CRT) Televisions

Vertical line on my TV

Posted on Jan 02, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I have horizontal lines across screen have to turn on couple times til it comes on voice will work but screen not on turn off on then pic an sound with lines across screen

Check and replace damaged component/s at its horizontal scan output section circuit. Check the LOT (Line Output Transformer) too for damage. Replace the horizontal scan output transistor. Check the input voltage to LOT. If the voltage is absent check the feeder resistor; if any. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
Type in this key phrase " my service table today " in the search box at the top right of the display window of the home page, to get gathered some pages which has the details of practical experiences to the author of that site.

Jan 01, 2016 | Standard (CRT) Televisions

1 Answer

White horizontal line is coming how to solve this

Since you changed the flyback did anything change? If not, you may want to take a close look at the horizontal peaking caps or the horizontal electroltic capacitor. I hope this helps.
If I can help any more, email me at
"Original Radio Man"

Feb 13, 2013 | Standard (CRT) Televisions

1 Answer

Tv problem

Check its horizontal output section circuit for any loose solder terminals. Resolder all suspected solder terminals by applying little more fresh solder. Replace the horizontal output transistor. If this transistor have some leak, it will overheat within minutes will shut down the picture.

May 26, 2012 | RCA 27F530T 27" TV

1 Answer

Horizontal lines on the the screen.

There is a way to post photos here or let me know where.

Mar 14, 2012 | Standard (CRT) Televisions

1 Answer

Panasonic CT-32G6E Intermittent single horizontal line

I would suggest to locate a part that looks like the one on this link and re solder all the pins, also check for any high power resistor nearby the IC295890 and put some fresh solder.
Let me know if you need further assistance.

Aug 07, 2008 | Panasonic CT-32G6 32" TV

1 Answer

Horizontal Line

A LINE left / right thru the middle ( horiz line) indicates a problem in the vertical circuit.First step is to solder the pins of vertical o/p
IC.........Next, troubleshoot vertical circuit to look for problem...T.

Please rate solution................................

Nov 15, 2007 | Hitachi 36CX39B 36" TV

1 Answer

No power.

Usually, in those Sony sets, a crack developes on a small transformer in the horizontal drive circuit, which causes the horizontal output transistor to short. This immediately shorts out the switching transistors in the power supply and blows the Sony 0.1 ohm resistor fuse. A shorted flyback (high voltage) transformer will also have the same result. The power supply does NOT need to be replaced. The parts should be replaced, the flyback checked and the board resoldered by a qualified tech familiar with Sony sets.

Aug 23, 2007 | Sony KV-32V35 TV

1 Answer


Yes, you should check other parts. The horizontal output transistor is more than likely shorted. Also the flyback could have gone bad. Some SONYs have problems with the horizontal driver transformer which is connected to the base circuit of the horizontal output transistor. If this little transformer has a loose solder connection, it will take out the horizontal output transistor. This may give you some insight as to where to look for your problem. Stargazer

Jun 11, 2007 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

Green screen with almost horizontal zigzag lines

Is good that you hit it and it reacts,very likely you have loose conections in different places but for the distorted picture you need to check the horizontal driver transformer and flyback after that is corrected you need to check the complete chassis for loose conections.Take your time.Good luck.

Sep 07, 2006 | Sony FD Trinitron WEGA KV-27FS100 27" TV

Not finding what you are looking for?
Sanyo DS32920 32" TV Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sanyo Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66685 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Sanyo Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides