Question about The Computers & Internet

1 Answer

Mpem on my 98 xp Ltd is fried,I have purchased a replacement however when I went to swap them I noticed the one he has sent me has three plug sockets when mine has only two, will they be compatible?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • The Master
  • 79,865 Answers

We have no way to look this up here.

Posted on May 18, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 seadoo gtx le popping the 5 amp mpem fuse

Not sure what you're dealing with, but it sounds like a short in the stator, as grounding the stator by putting a bolt in pops the fuse. Repair or replce the stator.

Jun 02, 2014 | Vehicle Parts & Accessories

3 Answers

Left low beam is inoperative. Replaced both bulbs,

I had the same problem with my 2001 Forester. Try this as a low-cost and easy repair attempt: buy brand new fuses and replace both L/H and R/H fuses. If one of your fuses is marginal, your headlights will exhibit this problem. Replacing my headlight fuses with brand new ones solved my situation.

Jan 18, 2010 | 2002 Subaru Outback

1 Answer

Electrical low-beam headlight wire on 02 Chevy Trailblazer burnt

Get yourself to a junkyard and pack yourself a light lunch while you're at it. Take a leisurely stroll through the junk that closely resembles the one you need parts for. Go to the closest wiring harness to the headlight assembly, take your time and don't go trying to **** it, and unplug it from the bulbs up front. Make a simple and straight forward swap and do take the time to stop and smell the junkers, it's quite relaxing! Then, you should seriously make sure your new wiring harness is properly grounded (!), which I suspect to have been a contribing factor to your problem of overheating the bulb socket. Do take the time to go over the stuff that should be grounded and make it so. Th e job is quite simple and well worth you taking the time to do it yourself.

May 27, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Viking Rose 605 does not read anything but Win 98.

Ebay may have a laptop with win 98 but that is a pretty old OS. No way to register the software without contacting Viking to ask them to allow you to register her old software unless she sent you the reg numbers. She can't transfer ownership to you without those numbers on a certificate. Only originators of the software can allow you to do that by overriding her registration. Contact VSM and ask them if they will do this so you can use it.

May 26, 2009 | Husqvarna Designer I

1 Answer

Horrible misfire and knock

0300 is a mis fire. Explains the fried wire. Were all the plugs changed?? If not, definately change the one on the fried wire. Possible burnt cylinder. Does it fire/start right away cold?? If not, it could be the coil. Start by checking spark in all your wires and plugs. This will isolate your issue hopefully.

May 05, 2009 | Chevrolet C1500 Cars & Trucks

1 Answer

HP Pavilion 774y power supply replacement

I doubt you fried the motherboard
I would be taking my old power supply to the store where you purchased it to make sure they gave you the proper one.
Some power supplys do have that extra plug you may not need to plug it in at all
I can't see your motherboard to show you where to plug it in wish i could help more

Jan 15, 2009 | HP Bestec ATX-1956D 200w HP Part No...

1 Answer

I am selling my SL1210 Mk2's and i turned them on this morning to check them and all was fine. A guy came round to look at them this afternoon and i went to turn them on and there was nothing!! I checked...

Have you tried connecting them to a different outlet? If they still don't work, then you fried your power transformer, and will need to get it replaced.

Unfortunately, the fuses don't provide much protection to the power transformer, as the line for these fuses are installed AFTER the transformer, and meant to protect the main Circuit Board only.

You can purchase the power transformer HERE. But I would not recommend self repair. Maybe you can include them in the purchase price, or knock off that amount from the purchase price.

You probably had a slight power surge, and didn't notice it. A common issue, unfortunately.


Mar 30, 2008 | Technics SL-1210 Turntable

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top The Computers & Internet Experts

Perry Ralston

Level 1 Expert

17 Answers

ashu k...........

Level 1 Expert

33 Answers

ted dux

Level 2 Expert

135 Answers

Are you a The Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides