Question about Televison & Video

Open Question

Hi. Worx drill 2 years old Light flashes and cuts out, like the battery needs charged. Bought new battery. Same problem. Also, at times, keeps going in same direction after putting it in reverse. J

Model no. Wx373.2

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 101 Answers

SOURCE: Broken Forward/Reverse Switch on Bosch Model 1198VSR Hammer Drill

Yes .. should find it here http://www.toolpartsdirect.com/bosch-tool-parts.html
Hope this is Helpful ! Thanks

Posted on Dec 16, 2008

Ad
rowdy45176
  • 2176 Answers

SOURCE: Low voltage light flashing

I haven't worked on one of them in years but I looked at a breakdown and the parts are as I remember. Go to Milwaukeetool.com and under parts/service type in your model number and view the wiring diagram for an operational check procedure. I would first look at the cord and is the base sitting on 1/2 or greater plate steel. If rusted or painted you will loose some of the holding force. Also I don't know what motor you have but some of the larger units require a lot of amps to operate and it is possible that even though you plugged it in direct to wall the circuit wasn't sufficient to operate both units. Last resort call the tech dept. at Milwaukee and see if they have any ideas. That panel is a component part as you know and there were no replacement parts for it. Hope this helps if not let me know and I will do some more checking

Posted on Mar 14, 2009

siawolf
  • 749 Answers

SOURCE: laptop battery charge indicator flashing amber and green

If the battery is hot from being used in your computer or being in a hot environment, the battery may not charge when you connect the computer to an electrical outlet.The battery is too hot to start charging if the batter15.jpg light flashes alternately orange and green. Disconnect the computer from the electrical outlet and allow the computer and the battery to cool to room temperature. Then connect the computer to an electrical outlet to continue charging the battery.
Regards..

Posted on Apr 14, 2009

  • 165 Answers

SOURCE: Brand new Makita DC18RA charger wont charge the batteries.

Return to store for replacement.

Posted on Feb 27, 2010

  • 1 Answer

SOURCE: The battery on my Worx GT doesn't seem to hold

the first time the Worx GT worked great since then I took it off the charger and it won't go more than five min. without going dead. I'm back using my gas trimmer what's up ith th battery on the Worx Gt

Posted on Nov 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery not charging


You didn't indicate the make and model number of your tool, but almost universally, all lights flashing on a charger indicate a bad battery. If the system in the charger detects that the battery has a short, bad cell or anything else wrong, it will not attempt to charge the battery.

Sep 03, 2012 | Drills

2 Answers

My battery does not hold the charge, i will charge it for 24/hour and it only last 5 minute, why is that, iI buy this product for wife when went to Iraq, and when i talked ton her on the phone three months...


NiCad batteries have this problem when they are recharged frequently after being only partially discharged. This is also the case when the batteries are left in the charger continuously - even if the charger is described as being "automatic". I have old 12v batteries that I have been using for 20 years, but I only charge them for a few hours, and only when they have run down enough to be useless. I prevent leaving them too long in the charger by using a timer that cuts the power to the charger after a couple of hours. A couple of years ago I bought new drills and chargers, and believed that the chargers would be automatic and so could be left plugged in. Those batteries only lasted a couple of years, while the old ones are still going strong. I now use the timer for any of these chargers, automatic or not - but I had to buy new batteries first. good luck, Al K

Jul 29, 2011 | Worx GT WG150 10 in. 18 Volt Cordless...

1 Answer

Worx cordless drill battery pack wont hold a charge at all its about 3 years old


If it is a Nickel cadmium battery, it has probably developed "memory" - that means it becomes used to partial discharge and the capacity has gone down.

You can partially revive it by deep cycling a couple of times, like this:

1) run the drill till it stops (can tape the trigger on, if necessary)

2) recharge fully

Repeat steps 1 and 2 , after that the battery should hold the charge a bit better. These rechargeable batteries do wear out eventually. Lithium Ion batteries are better than the Nickel Cadmium.

Jul 10, 2011 | Worx Drills

1 Answer

14.4 volt cordless drill --- yelloow and green light on lo0nger than 15 minutes, cannot find user manual.


The battery will no longer take a charge. Time for a new one. I had 2 like this in the last month. The batteries where 5 years old and been charge for over 800 cycles each. Age and cycles will wear them out.

If the tools is still good jsut get new batteries. But check the prices. I just bought a new drill and saw set for $90 and 2 new batteries were $60. I got a new set, since the drill was 8 years old and worn out.

Jun 30, 2011 | Ryobi Drills

1 Answer

I bought a Worx LWG151-5X3P LITH GT 2-IN-1 W/30 MIN CHAR. On 4/26/2010. When I try to charge the battery. The bottom red light keeps blinking indicating a defective battery. Is it the battery or the...


I would go to their website and check on their warranty policy. These units have reports of having bad chargers and batteries. New batteries don't always cure the problem. The manufacturer for these parts seems to have dropped the ball . Test the output of the charger when plugged in with a voltmeter. That will tell you if it is putting out the proper voltage as stated on it to charge a battery. Also, check the voltage of all your batteries; before, during, and after use. This will let you know the true culprit. After time, chargers fail due to the excessive heat they produce. A voltmeter is inexpensive and Wal Mart has them.,,,Radio Shack...etc
Worx website: http://www.worxpowertools.com/

Oct 22, 2010 | Garden

1 Answer

I bought a worx trimmer over the TV and it was charged to my Discovery card. This was April 28,2010 Total cost was $175.97. I bought it because I was so impressed. The worx does not work anymore. I am...


Barb,

I would get the phone number of the place you bought the trimmer from your discover card bill if you do not have the phone number somewhere else. Then call the company which you bought the trimmer from. Chances are the machine is under warrenty and they will give you a new battery or whatever the machine needs.

Aug 11, 2010 | Garden

1 Answer

The charging light flashes alternately in green and red color, charging is not possible.


You have defective batteries. Either they are old and used and can no longer take a charge and should be replaced, or they have a problem not allowing them to be charged.

If batteries are new, seek replacements. If old, time to buy new batteries.

If this happens with several batteries, and even new ones, your charger my be faulty.

Feb 27, 2009 | Makita 2 Bl1830 18v Battery,dc18ra Charger...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74243 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...