Kohler worth model r76256-4d-2bz pop up drain won't close

Hello Rhonda Tweedus,

Sorry it took me so long to understand such a clear question...
Your style: Bellera (couldn't find an answer either)

I looked around for PARTS LISTS...

Clever sales tactic ...

Perhaps FAUCETSDIRECT.COM
might help... (see bottom URL).

Their attached has three PDF data sheets... none of which give the DETAIL YOU REQUIRE...

I suggest you CALL Kohler direct at
1-800-4KOHLER (1-800-456-4537)...
They can IMPROVE if they don't know the have
a problem

Kohler 560 2BZ Oil Rubbed Bronze 2BZ Bellera Pull Down Kitchen Faucet with...

Carnac the Magnificent

Hello friend,
ALL of these taps (im english !!!) faucets ? have a LIFETIME guarantee. see http://www.faucet.com/kohler-k-8201-4-polished-chrome-taboret-centerset-bathroom-faucet-includes-metal-pop-up-drain-assembly/f230779#warranty-info


'To obtain warranty service, contact Kohler Co. either through your Dealer or Plumbing Contractor or calling 1-800-4-KOHLER or by writing: Kohler Co., Attn: Customer Service Department Kohler, Wisconsin 53044 U.S.A'

Worth a try !!! even if only to find out how to get them apart !!!!

There is a threaded rod in the over flow line. Take the plate off adjust shaft by screwing it out making it longer so the stopper opens more, or screwing it in to make it shorter so it will close the stopper sooner.

www.us.kohler.com/us/...Support

The plug has a little hole in the end - that rocker-arm lever fits through the hole. If the plug gets turned 90 degrees to the side before installing the lever, the lever won't go through the holeand the popup won't pop up. Pull the lever back out, rotate the plug 90 degrees with your fingertips or thumb, and put it back in. It may take several tries.

Did you check the remote terminals and relay in the ATS, disconnect gen remote wires, kill the ATS brealer and ohm across the start terminals, they should close, if not a relay/control board issue, if they do fault is in wiring or gen control, or incorrect wiring

NOT A EASY FIX,THE CABLE IS NOT ADJUSTED RIGHT,

you need to change the washer around the pop up

under the sink there is a arm that you can raise to push the button up higher in the sink however fist unhook the pin that holds the rod in place under the sink and pull the plug out and clen first then just adjust the arm one notch at a time to get it high enought. If you need more help just post here.

You need to call 1-800-4-KOHLER and get a replacement cartridge