Question about Hardware & Accessories
One of the four stays on, manual, timer and yellow all off but runs constantly.
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I fixed my problem by disconnecting the control board, cleaning all the contact points (including the ribbon cable) with alcohol and reconnecting everything as tight as possible.
I did notice that one of the contacts had become very corroded, so I scrubbed this one for a while. Prior to this I had done some selective unplugging and replugging (ribbon cable in particular) to no avail (each of these attempts powered on to beeping and no display).
Not a fancy solution, but it did work!
Posted on Jan 20, 2008
SOURCE: TEMPERATURE ADJUSTMENT
I had the same problem...and I accidentally discovered the solution...
One thing you have to remember is that the temperature that is shown on the screen is actually the room temperature and not the "wind" temperature.
To set the "wind" temperature, press the "m" button (aka temp/timer) once...it should show a flashing thermostat and the temperature screen changes to show the default "wind" temperature (it's 74 degrees)...
Next use the "down" button to the right of the screen to reduce the wind temperature to the desired temperature and that's all you have to do. IMPORTANT: if you wish to increase or decrease the temperature of the "wind" you just use the "up" or "down" button; DO NOT HIT "m" again since if you hit "m" again, it will cycle through the "timer" and then "temp" again, and it will reset the "wind" temperature to the default 74 degrees.
Posted on Jun 10, 2008
The gas burner needs to be scrubed to open the holes again. The transfer bar that lights the outside burners needs to be cleaned also. Make sure the tank is not cold and there is plenty of gas. Make sure the valve is all the way open on the tank. Its not a regulator problem if one of the burner lights and the others don't. Usually if you barbacue a lot the sauce drips down an creats crud on the burners. Just use a wire brush on the burners. You may have to take them out to scrub them good.
Posted on Apr 30, 2009
Tips for a great answer:
Nov 15, 2016 | Cars & Trucks
Jul 01, 2013 | Intermatic Malibu 121W Power Pack...
Jun 05, 2013 | Hardware & Accessories
Feb 03, 2013 | Hardware & Accessories
Aug 26, 2011 | Hardware & Accessories
Mar 15, 2011 | Computers & Internet
Dec 05, 2010 | Intermatic & Indoor/Outdoor Rain Tight...
Dec 07, 2009 | Gemmy Toys
Jul 02, 2007 | Belling SGE12X Front Load Washer / Dryer
39 people viewed this question
Usually answered in minutes!