Question about Frigidaire Kitchen Ranges

Open Question

Frigidaire error code f10 means what - Frigidaire Kitchen Ranges

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ctd80 hotpoint dryer error code f10

If you remove the back cover of the drier with the appliance un pluged, you will see the heater bracket.

un screw this from the back panel, and at the top you will see three thermostats. There is a brown one with a small hole in the middle, if you use a pin and press in, you should hear a click. This resets the thermostat and you should be able to use the drier again.

Apparently a common fault on these indicit based driers.

it worked on mine

Posted on Oct 28, 2007

  • 1 Answer

SOURCE: F10 error code on Hotpoint ctd80. How do I fix ? Thanks

remove 2nd largest panel on back of dryer then remove the heater unit (two small screws) from inside panel,on the top of this you will see two small units with wires going in and out both sides looking closer one of these units has a small hole using a pin push it down into hole this resets thermal cut out,you should hear a small click.

Posted on Aug 22, 2009

localwonder
  • 6784 Answers

SOURCE: Frigidaire oven F10 error code

HI, You will need to check the oven sensor wires that link the actual sensor to the main control board. Make sure that the contacts are connected properly, and not loose, or corroded. If all the wiring checks out, test the sensor for the correct resistance readings.(you will need a multimeter for this test)

The most common oven sensor should be approximately, 1100 ohms when at room temperature. The others may be close to as follows:

100°F - 1143 ohms
200°F - 1350 ohms
300°F - 1553 ohms
350°F - 1654 ohms
400°F - 1753 ohms
500°F - 1949 ohms

If the sensor test is adequate, and the wiring is Ok at the control, this will lead to a failed control board. replace the control in this case.

Posted on Nov 26, 2009

  • 1 Answer

SOURCE: I have a Frigidaire Gallery front load washer with E10 error code

When ours does that it is because of the hard water build up. We have to un-hook the hot water clean out the minerals and it stops doing it.

Posted on Dec 03, 2009

  • 506 Answers

SOURCE: we have a f10 error code on our electric range

F10 is thermal runaway. The RTD is most likely bad. Open the oven door and look in the upper corners you will see a little metal rod protruding from the back of the oven, this is the RTD or resistive temperature device. A local parts store should have these.

Posted on Dec 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code f10 and f29 came up while On self cleaning what does this mean ?


Washer Error Codes Below is a list of... - Elite Appliance ...

https://www.facebook.com/permalink.php?story_fbid...id...
Right now you will find error codes for Asko, Fisher & Paykel, Frigidaire, GE, Kenmore, LG, Maytag, Samsung, ... Check pump trap and clean. ... Musical series of beeps every 5 seconds and Wash cycle light flashing-Washer is overloaded. ... E47--Board thinks the door PTC circuit is open in spin .... F29--Door unlock error

Range Error Code F10: Troubleshooting Runaway Oven ...

? 2:20
https://www.youtube.com/watch?v=z6tcnpDKDns
Oct 1, 2015 - Uploaded by searspartsdirect
If you see F10 on your range, it means that your electroni. ... exceeds the temperature you set it at in either .

Nov 07, 2015 | Electrolux E30EW85EPS Electric Kitchen...

1 Answer

My Frigidaire oven shut off due to an f10 error which should I replace first since I have no tools to measure.ohms... sensor or EOC?


Good Morning mark, thank you for your post!

Based off the information you have provided your Frigidaire range is displaying an error code of "F10". An "F10" error code normally stands for a runaway temperature (overheating). This could be an issue with your RTD (Resistance Temperature Detector) or the EOC (Electronic Oven Control). I would recommend performing a reset on your oven and you can do that by flipping the household circuit breaker off for ten minutes. If you continue to experience an issue with the "F10" error code I would recommend having a professional technician out to your home for proper diagnosis and replacement of any electrical components. This will help you avoid any unnecessary part purchases. Hopefully this information has been helpful. -Matt

Feb 14, 2015 | Frigidaire Ovens

1 Answer

What does it mean when F-10 shows on oven display frigidaire range


Good Afternoon friend, thanks for your post!

Based off the information you have provided your range is displaying an "F10" error code. "F10" typically means that your wall oven has detected an issue with the runaway temperature (overheating).

Sometimes resetting your appliance can correct this issue but in the case that it does not and you still receive that error code I would recommend having a professional come out to properly diagnose and repair. At that time you could be having an issue within RTD (Resistance Temperature Detector) sensor probe or the EOC (Electronic Oven Control) having a professional come out would reduce the cost of unnecessary parts. I hope this information is helpful. -Matt

Oct 18, 2014 | Frigidaire Kitchen Ranges

1 Answer

F10 code meaning for Frigidaire range?


Thank you for your inquiry, friend!

Based off the information you have provided your range is displaying an "F10" error code. "F10" typically means that your wall oven has detected an issue with the runaway temperature (overheating).

Sometimes resetting your appliance can correct this issue but in the case that it does not and you still receive that error code I would recommend having a professional come out to properly diagnose and repair. At that time you could be having an issue within RTD (Resistance Temperature Detector) sensor probe or the EOC (Electronic Oven Control) having a professional come out would reduce the cost of unnecessary parts. I hope this information is helpful. -Matt

Oct 04, 2014 | Frigidaire Kitchen Ranges

1 Answer

What does a f10 code mean?


Good Morning Friend, that's a great question!

Typically error code F10 indicates that your Frigidaire range has detected an issue with the runaway temperature (overheating). Let's attempt reprogramming your range by either unplugging it or flipping the household circuit breaker off. It is best to wait roughly ten minutes and then turn on your range. Usually this will clear most false error codes. If issue persists, at this moment I would suggest contacting a professional to proceed further. Most likely the RTD Probe (Resistance Temperature Detector) or the EOC (electronic oven control) will need replacing. Hope this helps! - Z

Aug 11, 2014 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

F10 code after frigidaire wall oven on for 15 minutes


Good Morning Dave, thank you for allowing me to assist you!

If you are getting error code F10, it typically means that your range is experiencing an issue with the runaway temperature (overheating). One of the best ways to determine if this is a false error code is to reset the power to your range by either unplugging it or flipping the household circuit breaker off for about ten minutes. If the error code persists, I would be advisable to reach out to a professional to proceed further. Most likely the RTD (Resistance Temperature Detector) or the EOC (electronic oven control) will need replacing. Hope this helps!

Nov 21, 2013 | Frigidaire 30 in. Electric Gallery Series...

1 Answer

F10 error code on Model # FEFL79GCA Frigidaire Stove


Hello - Typically error code F10 could indicate a variety of issues. The range could possibly have a runaway temp (higher than normal temps), shorted keypad, faulty EOC (Electronic Oven Control) or, display wire harness missing/not connected. Usually, this code means to replace the EOC. You may be able to reset the range by disconnecting the power to the unit for up ten minutes. Usually this will clear most false error codes. You can disconnect power by either unplugging the unit or flipping the circuit breaker off and back on. If resetting the unit proves to be ineffective, I would recommend contacting a professional to move forward accurately.

Oct 24, 2012 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

Digital display is reading F10 and beeping and the oven shuts off after burning Banana Bread I also had smoke coming out the back panel of the stove top


Hello,

The F10 error code means that a button on the touchpad is stuck.The error code can be cleared by pushing the cancel/off button and if the F10 returns the clock needs to be replaced since on that model the touchpad is part of the clock.


GENE

Sep 23, 2011 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

F10


Hello,the F10 error code means "Runaway temperature"most likely the problem is bad Electronic oven Control ("clock/timer").it has to be replaced together with the overlay because it's glued to the clock.
Thanks

Jun 01, 2010 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

We have a f10 error code on our electric range frigidaire es510l what does that mean


F10 is thermal runaway. The RTD is most likely bad. Open the oven door and look in the upper corners you will see a little metal rod protruding from the back of the oven, this is the RTD or resistive temperature device. A local parts store should have these.

Dec 15, 2009 | Frigidaire PLEF398AC Electric Kitchen...

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Ismael Rodriguez...

Level 2 Expert

162 Answers

Mike Carew

Level 3 Expert

969 Answers

Are you a Frigidaire Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...