Output fault in my Jandy E1 series salt system

change the valve

it is showing your status aqua pure is set at 100% salt is at 4500 parts per million which is too high to operate should be between 2700 and 3400 to work properly you need to drain some water out and add fresh to dilute the salt general fault is because salt level is too high it is showing your filter pump and extra aux is on go to the equipment on on main screen it will give you a list of all your equipment any questions send me more info

general fault is the aqua pure either not enough salt or too much salt check salinty or the sensor or cell needs cleaning or replacing

go to system setup find aqua pure up setting from 0 to something and it will apear

salt should be between 2700 and 3300 or you will get general fault

if salt salinity is ok replace sensor

go into system set up youl see aquapure move it from 0 to at least 5% and it will show up that is if the red 4 pin is connected in the aqualink

chage salt system

sensor replace the salt chlorinator

clean or replace salt sensor make sure cell is clean also