Question about All-Pro Kerosene Garage Shop Heaters - All Pro PK115T Forced Air Kerosene Space Heater

Open Question

I have a 200T Pro Series Salamander. When it starts, it acts like it's not getting enough kerosene. Then it shuts off w/smoke coming out. When I try to restart it, it does the same thing.

It worked really good for the last two weeks.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 61 Answers

SOURCE: all pro 200t

It may be a reset switch on the heater. Usually located near where the electric supply goes into the unit.

Posted on Jan 10, 2009

  • 146 Answers

SOURCE: I have an All Pro

First thing is to download the service manual.

You need to make sure the filters are clean and that you are getting the proper air pump pressure.

If the units starts up and runs good and slowly goes out it will normally be due to a lack of fuel getting to the nozzle. When there is not enough fuel being delivered to the nozzle from either a clogged fuel filter of dirty air pump output filter the unit will slowly shut down from lack of fuel.

If the unit shuts down while it is running properly and the nose come is orange then you probably have a problem with a photocell or the flame out control.

If you have other questions you can contact our service department at 269-685-4125 at extension 224


M Cramer

Posted on Jan 05, 2011

  • 43501 Answers

SOURCE: I have a All Pro


Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater...

Reddy Heater - Troubleshooting Torpedo Heaters

Torpedo Heater Pump Pressure Adjustment



Posted on Jan 16, 2011

  • 1476 Answers

SOURCE: it keeps shutting on and


I have a tip at which explains the problem, how to fix the unit and where to get the parts, special tools and more information.

Thanks for using FixYa and for the great rating. Please consider a testimonial. Thank you.


Posted on Jan 19, 2011

  • 3917 Answers

SOURCE: i have a all pro


First of all make sure that the heater is filled with K-1 kerosene. Other fuel, such as gasoline, burn too hot causing the heater to burn out of control. Never use gasoline or any other fuel described as flammable. If there is any question about the fuel in your heater it is best to drain it and replace the wick and start with fresh K-1 kerosene. If you are sure of your fuel and your heater is giving off sooty black smoke it is a sign that the fuel/air mix is off. Make sure the chimney is seated correctly. If it didn't seat into place correctly after lighting you may be getting a very high flame on one side. If it's a high orange flame all the way around try rolling the wick adjuster knob down within the adjustment range - the wick may just be too high. If these things do not fix the problem wait until the heater is cool and inspect the burner cylinder. If there are any holes plugged with soot it needs to be cleaned or if it's dented or buckled it needs to be replaced. After you have checked the fuel and burner you should check to make sure the wick is installed at the correct height. Refer to the owner's manual for exact height. If the wick isn't installed correctly or there is no obvious defect it is best to take the heater to a service center to determine the cause.

Please get back to us if you have further query else please accept the suggestion.

Thank you for contacting

Posted on Jan 26, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where can I complete a dessertation within a week?

Thank you. The fact is, it is really very difficult to complete a dissertation paper within a week. But i can help you writing dissertation in a week. You simply click the following link and prepare dissertation paper within a week.

Jan 10, 2014 | SoftMath Algebrator - Algebra Homework...

1 Answer

1997 Kia Sportage Misfire on Cylinder 3

run a compression test on all cylinders to rule out head gasket or burned valve.

Mar 03, 2017 | 1997 Kia Sportage

1 Answer

1997 Kia Sportage Misfire on Cylinder 3

The injector is bad , internal coil when heated shorts out . Feel lucky it's only one injector . It could be like this corvette all injectors Quit when hot ! Test the injector with ohm meter . Chevy Corvette No Start When Hot The Diagnosis

Mar 03, 2017 | Cars & Trucks

1 Answer

Are depilatory creams a good way of removing hair from my bikini line?

That really depends. I find that depilatory creams are a better option that shaving my bikini line, which leaves the area stubbly and sore but it's not as good as waxing which has a much smoother and longer lasting effect.

Using creams is a good option if you don't have much time. The effects last for about a week, but just be warned that the cream has a really strong and unpleasant smell - so make sure you leave a window open.

Feb 18, 2013 | Health & Beauty

2 Answers

How can I charge Pamasonic DMC FS16 camera without having the charger with me. I'm on holiday and left my charger at home. I hoped the battery would last for a week,. A bit disappointed.

You can try plugging in the usb cable to your laptop, or any usb port really but the documentation is unclear whether that will actually charge the battery.

Really the only other really viable option is to find a camera shop, walgreens or tech store that could possibly carry the charger, or at least a spare battery.

May 26, 2012 | Panasonic Cameras

1 Answer

Mine shuts off and blinks red once it gets hot I think....I can put a fan in the back to blow air at it and it will work for a good while. The manual says it is not getting air but there is nothing really...

Clearly, heat is an issue if a fan helps it stay up longer.

After 5 or 6 years there may be an accumulation of dust bunnies inside it.

Unplug it and take the cover off. Blow it out, clean the vent holes and see what happens.

Jan 28, 2011 | Denon AVR-1604 Receiver

1 Answer

It keeps shutting on and off. i have a all pro 200T model.


I have a tip at which explains the problem, how to fix the unit and where to get the parts, special tools and more information.

Thanks for using FixYa and for the great rating. Please consider a testimonial. Thank you.


Jan 19, 2011 | All-Pro Kerosene Garage Shop Heaters - All...

Not finding what you are looking for?
All-Pro Kerosene Garage Shop Heaters - All Pro PK115T Forced Air Kerosene Space Heater Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top All-Pro Heating & Cooling Experts

Paul Carew

Level 3 Expert

3150 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

T bone 1963

Level 2 Expert

69 Answers

Are you an All-Pro Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides