Question about New Balance Exercise & Fitness
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: error message on recumbent bike
The problem might be the gearbox. I know because I have the same problem. Keys fitness is out of business, but "The Treadmill Doctor" has purchased the inventory of parts for the bikes. They will help you troubleshoot, and have parts available if you need them. The number is 1-888-340-0482. Or, you can go to treadmilldoctor.com.
Posted on Apr 03, 2009
If this is the same Stamina R360 as I have, you just hold down the orange oval button (labeled: MODE) until you hear a beep. This resets the readings.
Posted on Apr 13, 2009
Check the tightness of the crank bearings, also the crank fastening nuts (on axle) If its the gears you may have to turn the screws on the rear derailleur to adjust the tracking. The same as the front. Your question is kind of vague so its hard to pinpoint the clicking noise. Could even be a stone in the tire??lol
Posted on Feb 21, 2010
No speed/RPM reading, Console displays
"E3" error code
Check data cable integrity All wires in cable should be intact. If any are cut or crimped, replace cable.
Check data cable connections/orientation, insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place.
Check magnet position (requires shroud removal) Magnet should be in place on flywheel. If no magnet is present, replace the flywheel or the entire base unit (if unable to replace flywheel).
Check RPM Sensor (requires shroud removal) RPM sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary ( 1/8" clearance between sensor and flywheel) if still error 3 then check the sensor with a multi meter unplug sensor leads attach meter to sensor connectors. Have someone by hand rotate the pedal while you observe the multi meter opening and closing the internal sensor circuit if no change in meter readings then replace the sensor.
Posted on Jun 01, 2010
Tips for a great answer:
Feb 19, 2015 | Exercise & Fitness
Nov 25, 2017 | Cycling
indicates a speed issue. In this case, the motor speed as reported
from the optic sensor differs
the speed setting.
Optic sensor signal issue -- Either the optic sensor signal is not
right, or it is read incorrectly, or
signal is not reaching the display.
test the speed sensor for open or faulty. clean it, and tight the connector very well. see the diagram attached. However RUN the software calibration for easy fix it.
God bless you
Mar 21, 2013 | Schwinn 220 Recumbent Bike
Feb 07, 2013 | Exercise & Fitness
Feb 03, 2013 | Cycling
Recumbent bike works best for elderly people with back and hip problems
because of the relaxed position and the angle that put's less pressure on those
areas. Upright exercise bike works on more areas than the recumbent bikes
including the lower abdominal muscles.
Aug 09, 2012 | Exercise & Fitness
Mar 11, 2012 | Motorcycles
Jul 22, 2010 | New Balance 1400 Treadmill
Jan 07, 2009 | Ironman 430r Recumbent Bike
48 people viewed this question
Usually answered in minutes!