Kenwood KDC-135 remote wire

Hook it up properly to the deck remote on wire ,(Dude) End stay off the (Drugs)

on your amp under the back seat their are 2 plugs the one on the left which is the smaller of the 2 there is a Tan wire w/Orange stripe on it hook the remote wire from stereo plug which will be blue w/white stripe to that wire so it will power-up your amp...Bottom line, no amp = no sound,unless you figure what wires are the speaker wires and hook directly to your stereo plug............Its an easy fix

it sounds like you are using the blue wire (antenna remote turn on) instead of the blue/white wire (amplifier remote turn on) to turn on your amplifier.

Hello, my name is Israel and I will help you. The following should be able to help you out. Please rate and good luck.

constant 12+ orange
switched 12+ yellow
ground black/white
illumination gray/black
dimmer brown white
Left Front + tan
Left Front -

Check your wires to make sure they're not crossed. follow them all the way back to the radio if you have to. when it comes to subs, you have to get it right with how you connect your possitive and negative especially coming out of the amp. if you have rca's connected from the radio to the amp, then check the output to your subs from the amp to the subs, make sure theyre wired correctly. if you used your stereo wires for input to your amp, then make sure those wires are positive with positive and negative with negative. also make sure you have them hooked up to rear output only. don't use one rear and one front.

the wire colors in your mazda will not match the colors on the kenwood stereo. you need a test light to find the right wires

normally it's the blue wire marked power antenna on the back of the radio it normal size would be about a 12-14 gauge wire size

Hook the Blue/white striped wire to the power antena lead of the jeep (blue) to turn on the factory amp

Don

Hey Bandad, you will need 12 volts at the backup wire also. Try that and see how you go.

robotek

the remote is blue - the ignition wire12 volt is red - the battery line 12 volt is yellow