Question about Kenwood Food Mixers
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
It uses a different thread = turn clockwise to undo - not the normal turn ccw to undo and the nut is attached to the 2 blades.
Posted on Jan 12, 2009
A failed SCR or triac will not always show visually any sign of failure. Chances are good that is all that is wrong. If mixer had been plugged in when it got wet, that is all it takes. Also check the transient voltage supressors if the chef has them. They would be identified on the circuit board. as TVS or MOV along with a number. Only number to use is the one on the component.
If you can find ratings for the old devices, just matching the basic ratings should do. Just guessing, but the SCRs should be 20 amp and 400 volt, If the old ones are a lower rating than my guess, there is no problem with using the higher ratings, if my guess is low, go with the original's ratings. Manufacturer of device does not matter as long as ratings are at least comparable.
Posted on Jan 19, 2012
Tips for a great answer:
Nov 08, 2011 | Kenwood KM400 / KM410 Chef Classic Stand...
Dec 05, 2008 | Kenwood KM400 / KM410 Chef Classic Stand...
Aug 14, 2008 | Kenwood KM400 / KM410 Chef Classic Stand...
May 02, 2008 | Kenwood KM400 / KM410 Chef Classic Stand...
Apr 20, 2008 | Kenwood KM400 / KM410 Chef Classic Stand...
Feb 04, 2008 | Kenwood KM400 / KM410 Chef Classic Stand...
59 people viewed this question
Usually answered in minutes!