Question about Frigidaire Heating & Cooling

Open Question

I have a frigidaire window unit that is automatically cycling through the mode.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Unit does not defrost automatically


Faith I would not call that a professional what is the model number of the refrigerator

Apr 30, 2016 | Frigidaire Refrigerators

1 Answer

Frigidaire AC window unit, model fam185r2a (18,500 BTU) only cools for a few minutes before it cycles off and just fan blows. Then a few min later cool air cycles back on. Is this a thermostat issue?


The window units normally have a sensor thats attached to the front of the indoor coil. This controls the thermostat. I usually pull this sensor away from the coil because it stops cooling before the room is cool. It is attached to the cold coil so it senses the coil temp, not the room temp. You can normally see it when you remove the air filter. Don't break it! It may be a wire or small copper tube

Jun 10, 2015 | Frigidaire Heating & Cooling

1 Answer

Will not wash


motherboard of the unit may be defective

Dec 25, 2013 | Frigidaire FAFW3574KA Front Load Washer

2 Answers

Musty smell coning from window ac unit


You can spray glen 20 or similar into the return air filter with the unit running to kill the mould that is causing the smell, the other thing you can do is runn the unit on "fan only" mode for 20 mins after it has been in cooling mode before you turn it off. This dries the evaporator coil.

Sep 06, 2012 | Frigidaire Heating & Cooling

1 Answer

Frigidaire A/C window unit not cooling. I hear a switch cycling but I am not sure the compressor is working. No coils are cold. Fan works.


The switch cycling is probably the contactor-ley that with the help of the capactor will close the contacts and provide power to the compressor.

But finding the diagrams/schematics for a window air conditioner is hard so I hope you kept yours.

A general note, normally if the compressor is gone in a window unit, it is normally cheaper to replace than to repair.

Jul 22, 2011 | Frigidaire Heating & Cooling

1 Answer

I have a kenmore upright frost free freezer mod #253.26432100. A couple of months ago everything defrosted and the unit was not running at all. I unplugged it cleaned it and plugged it back in, it turned...


You have a problem with the ADC.

Frigidaire has also jumped into the market with an adaptive defrost board. The fresh food section light switch and light bulb must work. To initiate a defrost cycle, open the door and push the light switch in and out 5 times within 6 seconds. The compressor and fans should shut off and the defrost heater should come on. Open the door and push the light switch in and out 5 times within 6 seconds to remove the refrigerator from the defrost mode and back into a cooling mode.



This product comes equipped with an Adaptive Defrost Control (ADC). To activate manual defrost, press and hold the Freezer temperature UP (WARMER) key while pressing the Fresh Food temperature DOWN (COLDER) key 5 times within 6 seconds. A "d" in the freezer temperature window and "F" in the refrigerator temperature window will display when the heater is activated. To deactivate manual defrost, press and hold Freezer temperature UP (WARMER) key while pressing the Fresh Food temperature DOWN (COLDER) key 5 times within 6 seconds. "d" and "F" will be displayed until the defrost cycle is complete. (approx. 8 minutes)

Nov 23, 2010 | Frigidaire 20.3 cu. ft. / 575 liter...

1 Answer

MY FRIGIDAIRE DISHWASHER WILL NOT DRAIN. MOTOR ONLY HUMS DURING DRAIN CYCLE. OTHER THAN DRAINING IT SEEMS TO WORK FINE. DAY IT QUITE WORKING SINK BACKED UP AND WOULD NOT DRAIN


if there is still water in the dishwasher take the drain hose off from under the sink and use a large pot or mop bucket and but the unit into a drain mode usually by cancelling the wash cycle if the unit still does not drain.Then use a wet dry shop vac and attach it to the end of the drain hose to remove the water
after the water is gone check the drain pump for any kind of obstructions you may need to replace the drain pump

Jun 06, 2010 | Frigidaire 24 in. FDB1050RE Built-in...

1 Answer

Unit is shaking off the ground when going into final spin mode


it is unbalanced, you must contact your supplier and have him fit it properly. do not do anything or you will invalidate any gaurantees

Sep 03, 2009 | Frigidaire GLEH1642DS Front Load Stacked...

1 Answer

I have never used a self cleaning oven setting before. How do I start it? Afterwards what do I do? Do I leave the racks in? What is the routine? Thanks for your information! Barb


in general, if indeed it is a self cleanig oven, hte procedure is as follows.first remove the oven racks, then wipe up any loose dirt/grease from bottom of oven. next simply press the clean button( perhaps then pushing temp up button 3:00 will appear in display.) then press start, the door should lock and the clean cycle will begin.. Its important to realize that if this is the first time its run and if its real dirty the unit will smoke and smell real funny as cycle progresses, this is normal for the the clean cycle is actually incinerating the dirt/grease from unit. no need to panic and stop it but better to open a window and let complete the cycle, the door will automatically unlock whine the unit has cooled to a ssafe temperature, then open the door and wipe out the white ash from the oven floor

May 24, 2008 | Frigidaire Kitchen Ranges

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Heating & Cooling Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Donni Steen

Level 3 Expert

659 Answers

Bill Long

Level 3 Expert

587 Answers

Are you a Frigidaire Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...