How to replace hinges on a KitchenAid gas range model KGST307HBS8

hi deirde.
try this or go to the link at the bottom.
To replace oven door(s):

1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is completely seated on the hinges.
4. Push down on the top corners of the door to completely seat door on hinges.

How to remove and replace the oven door - KitchenAid Product Help

producthelp.kitchenaid.com/...Ovens.../Oven.../How_to_remove_and_replace_the_oven...
How to remove oven door Google Search

HOW TO REPLACE DOOR HINGES ON KITCHENAID WHIRLPOOL OVEN

should be the same, just your door might be heavier.

thers the inner most glass then some inner glass packs then the outer determine waht u need take ur model and go to sears.com go to there parts direct or parts research link lookup ur model find the part number and a normal price ........anyways u are gonna have to take the door off and replace it, kinda hard to describr just have to get acesss inside and replace the glass... might need service might be cheaper if u have a local repair shop for u to take the door off and bring it in to them... to get that dooor off most have lil flappers or metal locks open the door fully inspect down by the hinge pulll those flappers back towards glass then move door to brooil position 3/4 way closed and lift striaght up... hope this helps reply or rate me if posible k thanks

whirlpool oven wont turn on top burner work.
model #SF315PPQ2

earl am16 error

You need to put door back in the hinges , pull it up and slide it back.

If door does not fit, you may need to have hinges replaced.

See diagram below , click on picture to enlarge:

Place a hammer handle between the door and the frame at the hinge location.
Carefully apply pressure on the door to push the door closed.
This will often re-set range door hinges.

I have one of the kitchenaide gas ranges and if the burner cap is not set on PERFECTLY straight, the gas doesn't flow properly and will not ignite. Try lifting and replacing the cap back down on the burner and see if this solves it.

at about any appliance parts store in you area you just need your model and serial number there are links on this site kitchenaide is made by whirlpool so they can help or if you want to do it online this is good http://www.repairclinic.com/SmartSearch/smartsearch.aspx

screws near the hinge, make sure to get oven/tempered glass sometimes the screws are located in the crack between the oven and door on the bottom