Question about Televison & Video

2 Answers

Dlp samsung tv after 5 minutes i cant contrl the tv. i can't turn the tv off . the mdel # is HLP5065wx/xaa

Posted by on

  • riyadabuamsh Jul 24, 2009

    samsung DLP model# HLP5065WX/XAA. I turn the tv on it works all the night. when I try to turn the tv off it does not respond. So I have to unplug the tv from the main outlit. And if I try to turn the tv at this moment it will not respond. I notice also the standby and the lamp lightin front of the tv does not come on.

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,923 Answers

The lamp should be replaced and projection TV should work properly again. You also need to check the color wheel. If you think you'll have a hard time replacing the lamp and checking the color wheel if it's still working, contact an expert that would double-check your projection TV.

If the projection TV is still under the warranty period, I would suggest you to contact the manufacturer for free service.

Hope these helps and have a great day!

Posted on Jul 24, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

HI, this is the result of a failing control sector. this is part of the main PCB assembly. most of your on-deck manual controls are directly connected to this control board that is malfunctioning at this time. You will need to replace this faulty control board asap, if possible. this will correct and, restore proper control.


***(((I have searched for the actual part for your set that you will need to correct this issue to no avail. Usually, when the parts are not available, this will signal a discontinuation of the internals of the particular set. I would contact Samsung directly for the Board needed(Control assembly) for this repair. you may be able to special order it in this case. It is showing up as discontinued at this time in our data base)))

Posted on Jul 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Samsung DLP Tv turns off after about 3 minutes. What needs to be replaced?


i think it could be trip switch in the back of tv it should be a little blue button you can try put a bit of tape over the button it might work and if its that you can order a new one i put tape on mine and its still working

Feb 21, 2016 | Samsung HLS5086WX/XAA

1 Answer

TV lamp has been replaced, still won't come on, no picture. When turned on, I can see a blue, kind of sparking light and noise starts and does this about three times. TV powers down and does this again....


Samsung DLP TV Repair - No Picture - Replacing ...

? 2:41
https://www.youtube.com/watch?v=pBTgk_C5FVU
Jun 11, 2012 - Uploaded by ShopJimmy.com
DLP TV Repair No Picture Bad Lamp Bad Bulb TV Won't Turn On DIY Samsung DLP TV Repair How to replace Faulty LampTutorial Click Here to ... Rating is available when the video has been rented. ... is a replacement for the following DLP Rear Projection TV models: ... SAMSUNG HLR6167WX/XAA

Samsung DLP problems - Help! - ecoustics.com

www.ecoustics.com > ... > Home Video Forum > Projection TV Forum
Oct 26, 2009 - I have attached a picture of to show where the "Light Tunnel" is located. Upload ... So now I have a Samsung HLN5065W/XAA that I am willing to part out or sell as is. ... I replaced the ballast but the TV still won't turn on. .... The lamp has been sitting on a shelf until two weeks ago, when the TV went dark. Samsung DLP Light Ballast
Apr 10, 2009
Archive through October 26, 2009 - Samsung DLP problems ...
Apr 8, 2009
Samsung DLP Flashing Standby light
Jul 1, 2006
More results from www.ecoustics.com

Jan 19, 2016 | Samsung SELECT HLR6167WX/XAA Rear...

1 Answer

Why does my DLP TV turn itself off


Try replacing that lamp door switch, this has been known to cause issues in some Samsung DLPs

Contact Samsung at 1-800-627-4368 for proper part#

Oct 21, 2014 | Samsung HLP5063WX/XAA

2 Answers

Samsung, DLP TV 50 inches Model # HL-T5075X/XAA


Samsung just told me they wouldn't fix my tv because it was produced in Nov. of '06 and the only ones they would fix were made in August of '06 or earlier. I am way too angry right now to call the service tech number they so very nicely provided.

May 19, 2010 | Samsung DLP HL-P5663W 56" TV

1 Answer

Part number for color wheel


That model is a plasma TV? Plasma TV's don;t use color wheels. Only the DLP sets do.

Aug 15, 2009 | Samsung Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74136 Answers

Cindy Wells

Level 3 Expert

5103 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6694 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...