Question about DVD & Blu-Ray Players
My DVD player continually displays "reading" on my TV after a DVD is inserted. It will not play the movie. It does not say "no disc". I purchased a DVD cleaning kit, but this did not work. Any suggestions on what it may be?
SOURCE: philips 622 dvd player
Its time to clean the reader, thats a little laser eye in side the unit. that gets dusty, buy a cleaned disk, follow instructions, I bet ya this helps. DFD
Posted on Apr 11, 2009
the laser is probably no good or the tiny motor that spins the disc is no good.there is a clamper assembly that goes in the hole in the disc.turn it and see if it spins freely.there is a bronze bushing on the top of the motor driving it ,and a small drop of light oil on the bearing will make it work again if it is gummed up..if the motor does not get the disc speed from 250 to 600rpm,fast,the laser does generate the proper info and the computer says error.yes the motors can be replaced,but the cost is as much as a new one
Posted on Jul 03, 2009
You might have created a data cd, dvd player normally don't support data cd. If that is not the case then you the file format is not support by your dvd player.
You would have to search for a software to convert the file to the format supported by your dvd player. and write it on the disc again.
Posted on Jul 29, 2009
The safest way , this may sound really stupid but has always worked for me is give it a slightly rough slam on its bottom and it will work , dont judge this badly for it actually wotrks
Posted on Feb 16, 2010
Tips for a great answer:
Jul 12, 2012 | Philips DVD & Blu-Ray Players
May 30, 2011 | Philips DCP855/37 Portable DVD Player
May 03, 2010 | Philips DVD757VR DVD Player/VCR
May 23, 2009 | Panasonic DVD-RV31 DVD Player
May 01, 2009 | Sharp DVD & Blu-Ray Players
Jun 14, 2008 | Cyberhome CH-LDV 712 Portable DVD Player
May 28, 2008 | Philips Magnavox DVD/VCR Dual Player
86 people viewed this question
Usually answered in minutes!