Sewing velcro - my machine misses stiches so big gaps in the sewing - Do I use a different foot?

If you are sewing bias strips end to end, any foot would work. A 1/4" seam allowance is probably fine. You'll probably just need to cut the ends @ 45 degree angles and match them up before stitching. Sewing them at 90 degree angles creates a big bulk of fabric whereas 45 degree angles spread the bulk out when applied to your cushion fabric.

Learn How to Join the Ends When Quilt Binding Tips from McCall Quilting

The link below features 3 different videos on YouTube for you machine. Maybe there is something there that will help.

Google

if the sewing machine is brand new, then take it back and get another one

the sewing machine and foot pedal need to be checked for a short in the connections of the machine or the foot pedal or if the foot pedal needs to be replaced

SKIPPED STITCHES
1.the needle is not inserted correctly
2.the needle is damaged
3.the wrong size needle is being used
4.the foot is not attached correctly
if these suggestions don't help the the machine could be out of
time & the machine would need to be taken to a sewing machine
shop to be checked

sewingpartsonline.com
premiersewing.com

You need a heavy duty needle #16 or #18 to sew leather and teflon presser foot is helpful

Are you sure you have turned the foot button underneath the machine back to normal stiching and also then again for embroidary and have you placed the protective cover back for normal stiching once you removed the embroidary arm.

it sounds like the needle hook timing is out. You need to get the needle in the lowest position and measure the gap from the needle to the hook point on the bobbin shuttle. It should be 1/4". You will need to remove the foot and foot plate to be able to see. I use a 1/4" drill bit as a gauge. If you need to adjust it, you will need to remove the free arm cover to the right of the foot and loosen the 2 allen head screws that hold the drive gear. Adjust the gap, tighten the screws and retry. Usually if the needle catches the thread to early, it will make a bad stitch and the upper thread will break. If it catches to late, it will make thread loops and the machine will skip stitches. Good luck, these are a good machine and worth fixing. Phil

i bought a new brother stiching machine ls2125. when i started to stich the same no stiching is coming only the mark is coming. why?