My 1 plate induction stove has stopped working. Please tell me how can I fix this problem ?

Very specialised high tech tops need engineers to fix. It is likely to be the power board.

https://www.google.com/search?q=Schott+Ceran+stove+top+with+5+induction+hobs+no+power

..

I don't know, but it sounds like one of the heating elements are burnt out/no longer working. I had a similiar problem 5 years ago.. they're pretty easy to replace yourself if you are handy and have a screw driver. I think the one for my stove cost $18 to replace (5 years ago) here's the trouble shooting guide online for you model:
Maytag Range Stove Oven MIR8890AS0Troubleshooting Repair Help

what is the model number to your stove Carol

I have Bajaj Induction Cooker MAJESTY ICX 2 model. While it is working suddenly the display shows E4 and heating stopped. the on/off switch also not functioning. Pl. tell me how I will repair the cooker and what spares are required for repairing.
Thank you,
Susanta Banerjee
[email protected]

Had the same problem after overusing one of the bigger elements on my bellini induction stove / cooktop to boil copious amounts water. Element eventually stopped working and would just flash power level similar to when it cant recognise an induction pot, but also made a clicking noise over and over. My solution was to turn mains power off at meter box, and back on to reset the stove. When power came back on stove was working again! might have reset some sort of cutout sensor inside stove but cant be certain. Anyway, worked for me so give it a go and see if it helps. good luck.

E5 or E0 means that the stove is getting overheated. You have to reduce the temperature for it to stop. It goes on with few beeps and then stops.

Dear Sir,
i have Prestige PIC 1.0 induction stove.The issue with the stove is whenever i switch ON the stove the 2 Watt Resistor in the PCB(R50 After Diode IN 4007) getting blown off.Even after replacing the resistor also I have the same issue.Can anyone help me on this that where i have to check, whats wrong in the stove.? thank you


regards,
Prakash
Bangalore

Hi

The issue can either be a bad electronic control/clock assembly or the oven temperature sensor (probe) has gone bad. To solve this issue start by checking the oven temp. sensor for 1100 ohms, if the rating is more then 1120 ohms then it should be replaced however, if it reads between 1080-1120 ohm then check the control and door switch and replace the part that is bad. You can also check the wire harness from the control to the electronic board. Hope this helps...

Daniel

they do have issues i would take it back to the shop that fixed it the first time and ask them about a warrenty on the parts.

See the solution I posted here:
http://www.fixya.com/support/t519198-amana_acs3350as_never_buy_amana