Question about Honda Quincy 17 - Gallon Air Compressor with 5.5 Hp - G15H17PC3B

3 Answers

What are the timing marks for honda 5.5 gx160

Posted by on

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 583 Answers

They are marked on the gears arrow goes to dot

Posted on Aug 08, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 61 Answers

This link will take you to the full service manual. I Hope it helps.
http://www.honda-engines-eu.com/en/images/996.pdf

Posted on Oct 12, 2009

  • Engine head
    Engine head Jun 24, 2014

    are the cams the same for Honda GX 160 annd GX 190?

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have no time mark on my crank shaft

Posted on Aug 02, 2014

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 583 Answers

SOURCE: how do we get proper timing

the v on the camgear goes to the dot on the crankshaft gear, then slide the cam shaft in . it is now tmed. when you get to the tappets inlet .006 exhaust .008 any queries come back to me .

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the proper level on the dip stick for the oil?


There should be an area on the stick with cross marks on it. Try to fill it to the upper part of that cross hatch section

Feb 27, 2015 | Pramac ES3000 Alternating Generator With...

1 Answer

Honda gx160 will not run on idle


There are a few things i can think of that would cause that problem. #1 clean out the carb, some times when an engine sits for a little while the gas will gum up in the carb. #2 check the tuning on the carb, It is possible that the idle screw needs a bit of adjustment. #3 The gas could have gone bad. Again if it sits for a while and the gas cap doesn't seal properly your gas will go bad in a hurry.
Hope this helps.

Sep 20, 2013 | 5.5 HP GX160 Engine

1 Answer

Honda gx160 qh26 wont start, backfires thorugh exhst, new plug, re&re carb,valves in. .006 ex. .008 , sos please


The Honda GX160 is a single-cylinder multipurpose engine, so it doesn't have a timing belt, fuel filter, or any other wires other than the single spark plug wire and a ground. I'm having the same trouble with my Honda GX160. Spark is good, compression feels a bit lacking though, I haven't measured it. I've heard that the carburetor might be the cause, either needing to be cleaned or replaced as a whole. Dunking it in CLR works wonders, and if that doesn't work, you could probably find a new carburetor pretty cheaply.

Mar 19, 2013 | Cars & Trucks

1 Answer

Honda GX160 starts runs dies


How about the carb was it cleaned ???? It's definitely a fuel issue

Dec 16, 2012 | 5.5hp 6:1 Gear Ratio GX160 Engine

1 Answer

Why does my honda gx160 start and run for minute or two then cut off. Will restart


Hi, check the oil level. If low the oil guardian is cutting the spark. Regards Phil.

Aug 19, 2012 | 5.5 HP GX160 Engine

2 Answers

What is the valve clearance on a honda gx160


Valves are set at 0.15 intake and 0.20 exhaust (metric)

Jul 25, 2012 | 5.5 HP GX160 Engine

1 Answer

WHAT ARE THE TIMMING MARKS ON A HONDA GX160 ENGINE


I an not see a timing mark on the crankshaft gear to line up the cam gear any other method

Jun 04, 2010 | Honda Quincy 17 - Gallon Air Compressor...

Not finding what you are looking for?
Honda Quincy 17 - Gallon  Air Compressor with 5.5 Hp - G15H17PC3B Logo

4,802 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Air Tools & Compressors Experts

John Trevino

Level 3 Expert

1388 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Renee Knafel-Bullock
Renee Knafel-Bullock

Level 2 Expert

278 Answers

Are you a Honda Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...