Error clear misfeed at location B

DEAR SIR WHERE YOU REMOVE THE PAPER IN THE MACHINE THAT SECTION THERE IS PAPER PATH SENSOR ,THAT SENSOR POSITION IS ABNORMAL PLEASE CHECK THE SENSOR OF THAT SECTION WHERE YOU REMOVED THE PAPER


Hope this may help;

Regards,
VOTIT

just open the printer and check for any dislocation of the sensor or levers.

please clean the sensors located in the RADF and power the machine and the problem is over

This can be caused by a sensor (if he is mechanic) displaced the movable mechanism of the same and when it passes the leaf is joined, (if is optical, can be dirty the surface towards where it points the sensor, if he is not this, then the sensor is defective.
It disassembles the parts of exit, and verifies that the sensors are in good state and clean.

The MISFEED Indicator blinks when a MISFEED has occurred. Remove the misfed paper referring to the the description of MISFEED REMOVAL beginning on page 65 of the pdf Manual at:

http://files.sharpusa.com/Downloads/ForHome/HomeOffice/PrintersFaxMachines/Manuals/cop_man_AL2030_AL2040CS.pdf

When the MISFEED Indicator is blinking you should look closer at the paper feed area (see page 66 of the PDF). You may need to remove the paper tray to find any remnants of paper. If after closing the side cover the light does not stop blinking you will need to follow through as per the illustrated instructions.

Remember after removing jammed paper, you need to press the clear key to clear the MISFEED error.

If after doing all this the error signal has not cleared, power down the printer; unplug from the power supply; let rest 5 - 10 minutes; plug back i to power supply; turn printer on and see if this resolves issue.

Trust this is helpful. Please vote. :)

You need to consult your manual for all the paper paths that you may have missed.

Check all paths and go out and buy paper path cleaner, follow the instructions on the package and completely clean out the paper paths.

This should loosen or remove the stuck paper and get the printer printing again.

Please write back results (good or bad)

Did you take out the toner cartridge and paper trays and open all the covers to try to find the misfeed? If there is really nothing there, you can try turning the printer off and back on to see if it clears itself.

Clean the sensors in this parts and try reset the SC codes:Enter in the SP mode press 5-810 (SC code reset)select 1.Then hold down the Photo mode key and the +key at the same time for at least 4 sec.

try cleaning ur intake with throttle boby cleaner, an run some injecter cleaner through ur gas tank or use seafoam... (great stuff is seafoam).
if prob. persist check for vac. leak (u can replace all vac hoses for around $20-$25 bucks)
these 2 things should clear it up and r good things to do anyways weather it acually fixes it or not.
if thos dont work check ur sensors (tps, ias) u can go get a free check engine serv. done at autozone then ref. the codes to figure it out or let me know.
good luck and good jeepin