Washing machine clicking and flashing code F-30

The F30 error code will flash when the dispenser motor cannot be driven to its proper position.

* It could have a mechanical failure in the linkage between the dispenser motor and the top of the dispenser.
* Loose wire connection between the machine control board and the dispenser motor
* Failed dispenser motor

Even if it says whirlpool, I think this also applies to your case. Whirlpool Washer Diagnostic F30 Error Code WFW8300SW00

F30 code refers to a Dispensor Motor not engaging correctly. Start you cycle and usually you will hear clicking as the motor attempts to engage.

The F30 error code indicates an issue/error with the Dispenser System. It occurs when the dispenser motor cannot be driven to its proper position.

F30 Detergent dispenser system error. Bad or jammed motor.
Location is here :

Tech sheet is under the service panel:

Service manual

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

The F30 error code will flash when the dispenser motor cannot be driven to its proper position.

* It could have a mechanical failure in the linkage between the dispenser motor and the top of the dispenser.
* Loose wire connection between the machine control board and the dispenser motor
* Failed dispenser motor

The F30 error code will flash when the dispenser motor cannot be driven to its proper position.

* It could have a mechanical failure in the linkage between the dispenser motor and the top of the dispenser.
* Loose wire connection between the machine control board and the dispenser motor
* Failed dispenser motor

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

The F30 error code will flash when the dispenser motor cannot be driven to its proper position.

* It could have a mechanical failure in the linkage between the dispenser motor and the top of the dispenser.
* Loose wire connection between the machine control board and the dispenser motor
* Failed dispenser motor

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

F 30 code can be reset by un plugging power cord for 5 minutes also pull out the detergent dispenser and reach all the way in to the back there is a small plastic flapper valve move it from side to side with your finger this will rest code f30 and save a tech visit..

hI I HAVE REMOVE THE TOP COVER. YOU WILL SEE AT LEFT A PLASTIC ACTUATOR WHO MUST BE UNPLUG FROM ANOTHER PLASTIC PIN. JUST PUT IT BACK TOGETHER AND THE PROBLEM WAS GONE!