Question about The Toys

Open Question

What are the little red buttons on my controller for my 4 channeiareo drone quad copter

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
goliath01200
  • 665 Answers

SOURCE: Blade MQX QUAD-COPTER

It's difficult to determine witch trim buttons effect the props. The only way to do this is durring flight. At low power, since you are working with 4 axis, each set of 2 buttons will effect the rotational speed of 1 motor. Typicaly in this set up, the left stick will control power and yaw(up and rotation left and right), while the right stick controls direction and pitch.(forward/reverse and bank left or right) Here is what I think you need. The left side bottom butons, control horizontal control. If you take off and notice the helo going to the left(banking, not turning) click the right button to attain horizontal stability. If you notice it is going slightly forward click the bottom button on the right side of the left stick. The same can be said with the axis control on the right stick. I hope to see this aircraft on youtube, as there is a shortage of these flying stabile anywere. good luck.

Posted on Apr 22, 2013

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drone Tumbles?


could it be that the front propellers are reversed? I believe the top left propeller turns clockwise and the front right counterclockwise. If if that doesn't do it try placing the drone on a flat surface and holding the control with the joysticks at the bottom left and bottom right corners after pairing it with the quad. That's all I have. Good luck...

Dec 27, 2015 | Toys

1 Answer

How to change flight mode from a 2 back to a 1 setting this affecting my flight control.


Push the "Fine-tune Strafe left/right" (located under the right joystick) towards the right and hold it in postion, then turn the controler ON.

May 02, 2015 | Protocol Manta 4-Channel Radio-Controlled...

1 Answer

Quad copter won't lift off ground


Maybe battery is not accepting charge. I would try using a new battery.

Apr 20, 2014 | Protocol Manta 4-Channel Radio-Controlled...

1 Answer

Manta 4 channel rc quad-copter will not calibrate properly


Sounds like the axle is slightly bent and warped from the initial crash. Try replacing the axle and this should solve your problem.

Apr 19, 2014 | Protocol Manta 4-Channel Radio-Controlled...

2 Answers

Manta Quadcopter will not take off


the instructions that came with the toy are wrong. you have to turn on the remote first, then plug in the quad. Push left throttle up, then down. It should work now.

Jan 04, 2014 | Protocol Manta 4-Channel Radio-Controlled...

1 Answer

Leds stay on and do not blink,


Hi. I have the same issue.
RC has brand new batteries, switches on and see to work properly.
Quad is charged. But LED will not blink.
RC and Quad do not see to connect.
RC lights keeps blinking.

What happened ? As far as I know nothing unsual. I bumbed the quad slightly on the roof of the living room where I was fligh it. Nothing unsual. I landed it a bit roughly. Then it stopped responding. I assumed charge was empty but when I charged , nothing happened.

Dec 25, 2013 | Protocol Manta 4-Channel Radio-Controlled...

1 Answer

Copter is charged. it wont respond to the rc though


Turn on the remote control first then the heli the instructions are wrong
(I have the heli)

Dec 25, 2013 | Protocol Manta 4-Channel Radio-Controlled...

1 Answer

Missing manual, batteries not charging, quad copter not taking off


Go to this page: http://www.helipal.com/faq.php
and scroll down to the technical FAQ and the Walkera FAQ

Feb 09, 2013 | Walkera QR Ladybird Z-02 Canopy

1 Answer

I have a nano copter blaster 3D. I have put new batteries in the remote control. When i switch the remot on I get a red light and nothing else happens. It was bought for some friends who returned it...


You have to charge the copter first. Open the cover on the remote control and plug the little cord into the bottom of the copter. Make sure the copter is turned off. Switch on the remote and you will get a green light which means it's charging. When it goes red (about 10 min) it's charged. Then uplug it, turn on the copter and fly!

Oct 10, 2010 | Toys

Not finding what you are looking for?
Toys Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top The Toys Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Lawrence Oravetz

Level 3 Expert

9742 Answers

Gary Queen
Gary Queen

Level 2 Expert

85 Answers

Are you a The Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...