My crafter bus no power to driving driving 80 only

The color doesn't matter. What you want is power from the accessory bus. I usually pick an empty fuse slot on the row that is only hot when the key is on. I connect the stereo wire to the cold side of the fuse slot and put a 10amp fuse in. You need to connect your wire to the BACK of the fuse slot so the wire doesn't stick out the front of the panel. Ok?

Check the hydraulic clutch, it must have a leak.

might help
VWVortex com VW Crafter Clock set up

VWVortex com VW Crafter Clock set up

HP DX2300 Drivers
Please visit the above link and download/ install the Chipset Drivers. This would install the SM Bus Controller as well

Hope it helps! Good Luck! Thanks for using Fixya!
CreativeTECH

click start control panel administrive tools ,computer management ,device manager scroll down universal serial bus controllers you should see a yellow question mark?
right click to reinstall driversmake sure the lead/s that attach to this drive have a secure seating and are not bad/faulty the light on only tells that its getting power it might not be getting enough power you might test the lead/s or
just replace the cable of the hard disk, when you plugged the external disk drive you got that windows could recognize the USB device change the cable everything should work fine again, sometimes the wires inside the cable will be damaged due to bending or stretching or placing heavy equipment upon the cable,
hope this helps

Connect it to a different DESKTOP computer. If it still is not detected, then there is a hardware problem. Exercise the warranty to get it repaired/replaced.

If you are asking if you will be able to replace the first one with the sata one ...the answer is that almost all Hdd will fit in any desktop ...(I assumed that you are talking about a desktop ) ..with the condition that you have a SATA bus available ...on the motherboard..and all you will need if you do not have is a cable for sata and a power supply cable to attach on the existing ones..after that reinstall the computer ..and it will work ..
Even if your motherboard is not equipped with a sata bus...you can always get an adaptop ..sata to IDE and plase it like a regular ide drive ..

Connect the Hard Drive and restart the Computer. If it's not detected then open the Device Manager, click on the View menu and select "Show hidden devices".

Next, click on the plus sign next to the "Disk drives" and uninstall all the devices that you know are not present. Uninstall all the devices listed under the "Storage Volumes" and the "Universal serial bus controllers". Avoid all the reboot prompt until you're done uninstalling all the devices. Also make sure that the Device Manager doesn't have any exclamation mark beside any devices.
After uninstalling all the devices, restart the Computer with the Hard Drive connected.

check the jumper settings of the hard disk and power , bus connector