1100ml x and z reports - Office Equipment & Supplies

Hi, try this:
How to Erase the Memory on Royal Cash Register

Some registers have a small trigger in a hole under the drawer (between the two back feet). Flick this to open drawer. If no trigger, take the screws out of bottom of drawer and wriggle the metal base until drawer pops open.

The only way I have found to reset this register was to pull the battery's and start all over again like it was new. if you did not back up the register then any inputs or plu's will be erased. Don't know any other way. had to reset mine twice now and put a few hours into re-programming the plu's. back-up made it easier to load last configuration. connects to a serial port on a computer and run the software that came with the register. Also since mine continues to mess up with a managers password and locks my machine I no longer use a password protect mode no do I lock out x and z reports. Think this model has a glitch since I have seen more than 1 person with the same problem and no real cure. lots of luck

The Royal machines aren't as common. I haven't worked with these. you could try C-tech
https://the-checkout-tech.com/manuals/cashregisters/Royal_Alpha-1100ML_instruction_and_programming_manual.html

1000ml or if you change oil filter as well 1100ml rarely does this happen but if you drain frame oil and oil lines and change oil filter then the total oil would be 1200ml

Slightly warm the engine remove oil filler cap remove sump drain bolt and allow to drain
remove oil filter cover and remove oil filter wipe out excess oil with clean rag
install new filter and bolt on cover install sump drain plug
refill with 1100ml oil of your choice - Your Done!
Additionally you can remove the oil strainer basket from the frame but no one does this too often if at all
regards Jamie

If you just doing periodic oil change then 1000ml if you are changing oil filter aswell then 1100ml
regards Jamie

Slightly warm the engine remove oil filler cap remove sump drain bolt and allow to drain
remove oil filter cover and remove oil filter wipe out excess oil with clean rag
install new filter and bolt on cover install sump drain plug
refill with 1100ml oil of your choice - Your Done!
Additionally you can remove the oil strainer basket from the frame but no one does this too often if at all
regards Jamie

Slightly warm the engine remove oil filler cap remove sump drain bolt and allow to drain
remove oil filter cover and remove oil filter wipe out excess oil with clean rag
install new filter and bolt on cover install sump drain plug
refill with 1100ml oil of your choice - Your Done!
Additionally you can remove the oil strainer basket from the frame but no one does this too often if at all
regards Jamie

Printing Service Reports
1. To access Service reports, follow the Entering UI Diagnostics procedure.
2. After entering the Access Number, press the Machine Status button on the Control
Panel.
3. Select the Billing Meter/Print Reports tab on the display.
4. Press the Print Reports/List button.
5. Press the CE button.
6. The following reports can be printed.
• Debug Log Report
• HFSI Report
• Jam Report
• Shutdown Report
• Failure Report
• Protocol Monitor Report
7. Select the required report and press the Start button. The selected report will be printed.