Question about Samsung Televison & Video

1 Answer

Samsung 50" tv that wont turn on, but does have a red light. (UN50EH5000FXZA) I ordered a new power supply board with no change. (BN44-00668A) Now should I order the main board? (BN96-28946A)

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Samsung Master
  • 74,630 Answers

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Posted on Dec 23, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Samsung LN46D630 Wont turn on


http://www.tvrepairdoctor.com

Oct 26, 2012 | Samsung LN46D630 LCD TV

1 Answer

My 50" samsung projection tv


Hi,

Your power supply board is dead, you know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.


I hope this will help in solving the problem.....

May 13, 2011 | Samsung PCJ522R 52" Rear Projection...

1 Answer

I have a 50" lg tv wont turn on red light will


The tv power supply board is dying.That the board,where the power a/c acord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Apr 02, 2011 | LG 42LC2D 42 in. LCD HDTV

1 Answer

32" samsung tv wont turn on standby light stays red but it wont change with remote or by preesing it


Tries unplug,replug the tv back like an hour later.The tv,now will reset itself back to the factory setting.The tv should work now.If not,this problems,usally the cause it by the power supply board not responing and giving the the right voltages to the tv anymore.Tries websites like Shopjimy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Oct 22, 2010 | Samsung LN32A330 32 in. LCD TV

1 Answer

TV wont turn on


a bad power supply is most likely cause of this. Other possible cause is bad main circuit board.

May 03, 2010 | Samsung HL-S5086W 50" HDTV

1 Answer

50in samsung hd tv scrren wont turn on...red lights just keeps blinking


Change bloated caps on power supply pcb. You'll see them clear. That's should be it!
$10,00 for parts+ couple hours of labor and, you good to go!
95%. If you won't find any bloated caps, relax, it's time to get a new signal/main board. Can't fix those! Only replacement. Used one is ok.
My last case was a similar, 50" Samsung lcd panel with 4 1,000.00 mfd/16v.
good luck.!

Jan 23, 2010 | Samsung LE32R73BD 32 in. HD-Ready LCD...

3 Answers

Red light blinking, tv doesn't start


Your TV is in Protection Mode right now. A part inside the TV has failed and the TV will not turn ON to prevent other parts from being damaged. The red light blinking is an error code for diagnosing the problem part on the one of the power supply boards. The problem boards that need to be looked at is the Backlight Inverter Board or the Main Power Supply Board.
There is a slim chance you can leave the TV unplugged for an hour so the TV can discharge and reset itself. But other than that, I would use the warranty if possible. The TV repair shop maybe expensive, so get some price quotes to see if it worth the trouble.

Sep 09, 2009 | Philips 50PF9631D 50 in. HD-Ready Plasma...

4 Answers

Samsung flat screen wont turn on red light just flashes..


wont turn on red light just flashes?
On my samsung flat screen tv when you are watching the televison there is no red light on the power button but when you turn the television off the red light stays on all the time? what can I do to turn this light off?

Jul 20, 2008 | Samsung LE32R73BD 32 in. HD-Ready LCD...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74630 Answers

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...