Kenmore coldspot refrigerator model 52552100 makes ice but wont dispense it

It is possible that there is a switch for the dispenser light on your Kenmore Coldspot refrigerator. Some models have a separate light switch that may be located near the dispenser or inside the refrigerator compartment. You can try checking the user manual for your specific model or contact Kenmore customer service for more information.
If the dispenser light still does not turn on after checking for a separate switch, there may be an issue with the wiring or control board for the dispenser. In this case, it may be best to contact a professional technician for further diagnosis and repair.

If you can hear the auger motor turn, you may have a large chunk of ice in the hopper.

Ice maker will not dump ice, makes it but will not dump ice.

these have to be in correctly to lock back in and allow the unit to function. Try removing the bin again and be sure there isn't any small pieces of ice trapped anywhere. Also make sure there aren't any broken pieces from the bin. Hope this helps. Good luck.

my kenmore elite side by side refridge model 52699100 wont get cold

Hello.... do you still have the parts??

I can use Part 921526 PC Board kit, emitter & reciever icemaker - $30.

You can email me at [email protected]

Thanks,

Paul

could be your ice maker or your water valve

DID YOUHOLD THE DISPENSER FOR A LONG TIME AND PURGE AIR ??? ARRE YOU GETTING ICE???

i have kenmore side by side model 52552100 and the ice maker will not send ice thru the door. I is not even making any sounds when I push the button dispense. Can you duplicate this problem

hi LOP7,
In most cases you can easily solve this problem.
step one would be to make sure your freezer is getting cold enough. If you have icecream in your freezer is it frozen solid or is it soft. Most icemakers cycle around 0 degrees and if your freezer is not getting to 0 then it will not cycle and it will not make ice.
Step two would be to make sure you icemake is cycling. To do this simply lift the little shut off arm on your icemaker and wait about an hour then go back to the icemaker and drop the arm down. The icemaker should start going through a cycle. You should notice the arm slowly begin to raise and the ice dispencer fingers will begin to turn. Then you will hear it call for water. You may hear a humm.
If the freezer is cold enough and the icemaker is cycling that only leaves the inlet valve. replace the valve and enjoy the ice.
If the freezer is cold enought and the icemaker does not cycle, then you have a bad icemaker. Simply replace the icemaker and viola.
Third if the freezer is not cold enought 0 defrees. Then you may have a defrost problem. In this case post more info and I will be happy to help. Good luck [email protected]