Where is the learn switch on my elite gate opener

The latching delay is an important safety feature on an Elite gate opener, and it is not recommended to defeat it. The purpose of the delay is to ensure that the gate is fully closed and in the correct position before the magnet engages to latch the gate. Disabling the delay could cause the gate to not close properly, which could be a safety hazard and may also damage the gate and the gate opener.
If the magnet is not grabbing the gate on the first impact, there could be several reasons for this. One possible cause is that the magnet is not properly positioned, which could cause it to miss the gate on the first impact. In this case, adjusting the magnet's position may help.
Another possible cause is that the gate is not aligned properly, which could prevent the magnet from making contact with the gate on the first impact. In this case, adjusting the gate's alignment may help.
It is recommended to refer to the owner's manual for your Elite gate opener to learn more about the proper position and alignment of the magnet and the gate.

Sounds like the transformer is bad, if it is not the transformer then one of the voltage regulators is burned out. The system is designed for 12 or 24 volts.

Hi Mary, do you have more than one remote for the gate? Your remote needs to be paired with the gate receiver. Normally you need to push a certain button on the control panel to enable learning mode then you press the remote button you want to use. You will have to follow this learning process for your device. Please keep in mind that just any remote will not work with your gate, it needs to be on the same frequency and use the same modulation mode.
Hope this helps.

not sure if the manual can help
http://www.amazinggates.com/v/assets/manuals/elite-sl_3000-manual.pdf

The elite comes with a liftmaster receiver located above the control box the older kinds were metallic under thelat cover there is a small learn button.

hi,
You have to oppen the motor control pannel. There will be circuit board inside it. In the circuit board you can see a Push button switch. It is the learn switch.

After powering ON press and release immediatly this learn switch. With in 30 seconds press and hold the button you wish to use until two click heard from the control board.

If you can sent me your email id through FixYa then i will sent the picture which shows the learn switch.
OK.

Follow the instructions on homelink's website for programming a garage door opener with a learn button. The learn button on the miracle one is inside the control box. After you remove the cover, you'll see the radio receiver on the left side near the bottom of the control box. The learn button is near the front edge of the receiver.

Well it seems that their could be a limit switch problem. also if someone has replaced the limit switch they could have not connected the wires back up correctly. if your wiring and switch are correct than you have a bad circuit board. my opinion is to not even fix it and replace the whole opener with a gto-pto gp sl50 They are the most reliable opener out so far and come with all the features that elite charges extra for like a battery backup for instance.

The Learn Button is in a Silver little metal box that is in the opener housing but separate from the opener itself, pry off the case which kinda wraps around the reciever, it will say liftmaster of chamberlain the learn button will be in the reciever

the elite does not have that function, your are going to need to look for a time clock that holds open your gate...... the outside phone system or a programmable time clock that has been added to your gate...... oh this is an old post sorry. :)