I have a Kenmore top load washing machine. I just did a load and it was fine. I went to start a new load and turned on the washer; the agitator starts but there is no water coming in. As the agitator moves, I hear bits of water go up the OUT pipe. It's almost like the last load was interrupted and it is resuming its cycle, but as I said, the last one washed, rinsed and spun just fine.

Check here...

https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Washing-Machine/47-6-607241-/New/Kenmore-Washer-Won-T-Spin-Or-Agitate-417-43142200

Give their techs a call at their 800# before throwing parts at it.

Best to you.

WHAT IS WRONG WITH YOUR WASHING MACHINE?

For a detailed Washing Machine illustration, click below.

Top Load Maytag Style
Top Load Whirlpool Style
Top Load GE Style
Front Load Maytag Style
Front Load Frigidaire/GE/Kenmore Style
Warning! To avoid personal injury or even death, always disconnect your appliance from its power source--that is, unplug it or break the connection at the circuit breaker or fuse box--before you do any troubleshooting or repair work on your appliance. Also, because some components may have sharp edges, use caution while working on your appliance.

Some problems that can occur with your top-loading washing machine are:

There's an error code on the digital display

It doesn't work at all
It won't drain
It doesn't spin
It doesn't agitate
It's noisy
It leaks
It's off balance
There's no hot water
There's no cold water
It's slow to fill
There's no water at all
The clothes are wet after spinning
The cycle doesn't advance
There's no delicate or regular spin or agitate
It's overfilling
It's underfilling
The water temperature is incorrect


Hope this may help;

DON'T FORGET TO RATE:

your dogs may be bad in the agitater.. if u open the lid and turn the agitater back and forth does it rachet or does it turn freely both ways?

Take and turn the agitator by hand. It should only turn one way. If the agitator will turn freely either way, then you will need to replace the "agitator dogs" that go in the top of the agitator. Take a look at this video.

Try this link Washer agitator video

you may need a drive coupler replaced

HI, this is exactly what you need to eliminate this issue.i will list the part number below. you can click on that number to order the kit directly from the parts store if you wish.


285727

You have a broken lid switch. Check to see if the switch is broken off of the two screws that hold it under the lid. If it is, get a new one, take off the case and replace old switch with the new one.

the agitator dogs are problably remove agitator cap remove bolt holding agitator in ..dogs are part #80040

i have the agitator dogs, but my agitator is not turning. Can you help me in getting it off. kenmore model 11022954100. please help !!!!!! wife is tearing me up!