Dishwasher wont go through the cycles

Sounds like control is bad.

is there any error codes showing

most likely the water valves are stuck

Common Problem

1. Confirm the wash water is hot
   1. Try heated wash(sani wash) if available
   2. Run hot water in sink to warm up before starting
   3. At least 120 degree Fahrenheit water temperature
      
2. Open door check wash arm position start washer for a minute
   1. Confirm wash arm has rotated
   2. Check for plugged spray tips at either end of wash arm.
   3. Use small tweezers to remove
   4. Check for rack and dishes interfering with arm rotation
3. Place cup in upper rack with opening up cycle washer.
   1. Confirm that cup quickly fills with water
   2. Not washing check water level in tub mim 1 1/2 inch
4. Discontinue use of rinse/dry liquid additive.
   1. Confirm rinse/dry additive not leaking from dispenser into tub
   2. Washer detergent contains sparkle additive and too much sparkle/rinses/dry additive will coat dishes
   3. Try alternative wash detergent that contains minimal rinse/dry additive and use without liquid rinse/dry additive.
5. It will take several wash cycles after the elimination of rinse/dry to purge the oily film from dishes and machine..
6. If success "joy" is achieved with no additives then cautiously add back wash detergent with additives. Additives are important to facilitate drying and protecting the glassware china from leaching. The leaching process permanently etches the surface of glassware leaving a cloudy appearance.

What do you mean, it won't "run past the wash cycle"? Do you mean it stays in the wash cycle forever? Or do you mean it quits in the wash cycle and doesn't rinse or dry?

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Unfortunatly you are looking at the timer which is now built into the controller which would need to be replaced. If the relays are fused shut on the timer or the gears are missing some teeth then you will only get sofar I the cycle and the washer will just stay where it's. Sorry

did you get a solution for this? I am having the same issue. Please email me at [email protected]. Thanks -Eric

hi

make sure you are using rinse aid as this helps to evaporate the water at the end of the cycle in the drying stage. I know tablets have rinse aid built into the tablet but this can wash away on some wash cycles and do nothing so even if you are using tablets i reccommend still using rinse aid.

I just read this for the same problem: push sanitize, then heat and dry, sanitize, heat and dry, sanitize, heat and dry, cancel, then open and close the door. It worked. The dishwasher is running correctly even as I type this. 

Check disposer plug. If a garbage disposer has been recently installed, it is possible the disposer drain plug was not removed. The drain plug is a plastic piece in the disposer that blocks the hole where the dishwasher hose connects. Also check the hose connected to the disposal. Mine apparently had a kink in it. When I straightened the hose the dishwasher drained at full speed (I recently had a plumber re-route a hot waterline. He must has bent the hose). Hope this helps. If not go to the GE website. That's where I found my answer.