Reset to fabric - Sewing Machines

Check the stitch length to see if it is set at no feeding (0) if so, reset the stitch length to between 2 and 3. Also, check to see if the feed dogs are up and will help guide the fabric. One other thing is sure to use the right needle size for the fabric you are trying to sew. Included a link with full possible issues to correct the problem. My fabric is not feeding properly Brother

if your question is that the fabric didn't feed when I tried a zig-zag stitch , well then this might be a normal thing to happen on your machine , some machines when set to MAX size zig-zag stitch retract the "feed dogs" as you call them so that the operator can hand move the fabric around under presser foot , this is task called "darn" and its usually for filling large holes in fabric (socks!!) and for adding embroidery too (special needle)

this kind of sewing macines have a digital reset option
once you,ve done taste it again
make sure is well lubricated the main head gear

Once the presser foot pressure adjustment has been made it is a matter of matching the pressure to your fabric. Using a coin turn to button clockwise to tighten ( as for heavier fabrics) and anti clockwise to loosen (as for lighter fabrics). It will be up to you to find just the right settings depending on type of fabric and thickness.

sounds like the timing is off and will need a service call to get it reset. your local fabric store should know who you can call.

Refer to the manual. If there isn't any information there. Call your Janome dealer and ask to speak with the service person.

hi! there,
set dial tension to #3 and stitch tension to #12 try on straight
sewing,check bobbins winder if thread was wind on clockwise rotation before sewing.if ok try to sew and observed the change.

have a nice day regards,dont forget to rate me
thank's

h! there,
fabric moves forward when machine run due to movement of feed dogs,feed dog has a teeth, when your foot presser goes down attached to fabrics the pressure hold the fabric between pressure foot and feed dogs that why when machine run feed dogs pushed fabric when recieved stitch.try to check adjustment of feed dogs it maybe set at rest or neutral.reset it to upward towards needle.check also bobbins thread if accumulation was build up under feed dogs.regard and have a nice day.

Probably the most important contol on your machine is this one that regulates your top thread tension there are reason for having to reset your tension.Classified your fabric that you are using there are several set up of tension in every fabric that you use.Cotton fabric is most easier other than silk fabric make a record on this set up.The required tension depend upon the stiffness of the fabric,thickness,layer of rabric to be sewn and required stitches.Try cotton fadric turn tension dial to N0. 3 and Stitch set to from 8 to 12 defend to what is nice to you.