HI: I am living in ASrgentina, and have a CESSNA RUDDER PEDALS. This pedals is broke in your adjust of tension central control, how can i find this accesory ???

adjustable pedal relay Adjustable Pedals System Components
The adjustable pedals system consists of the following components:
• The adjustable pedals position switch
• The driver seat module
• The adjustable pedals relay
• The adjustable pedals motor
• The brake pedal position sensor
Adjustable Pedals System Operation
The adjustable pedal system is controlled by the adjustable pedal switch or the driver seat module and operation can occur only while the transmission selector lever is in the PARK position. The adjustable pedal assembly is moved forward or backward by a motor, which is fixed to the brake pedal actuator with a drive cable to the accelerator pedal actuator. The adjustable pedal motor is operated by 2 motor control circuits from the adjustable pedal relay. In an inactive state, both of the motor control circuits are closed to the ground contacts within the relay. The relay coils may be energized by the relay control circuits from the driver seat module or the adjustable pedal switch. When a relay coil is energized, the motor control circuit is switched to the battery voltage supply contact. The adjuster motor is bi-directional and the direction of the pedal assembly travel is determined by which of the motor control circuits is closed to battery voltage, while the other remains grounded.
The driver seat module monitors the location of the adjustable pedals using the brake pedal position sensor. The brake pedal position sensor is supplied with 5-volt reference and ground circuits from the driver seat module. The position sensor signal circuit is referenced from ground within the driver seat module. The signal voltage monitored by the driver seat module ranges from 0.39-4.58 volts and is determined by the wiper location on the resistor within the position sensor. The position sensor circuit voltage level is used by the driver seat module to determine the position of the adjustable pedals when storing or recalling memory position settings.

howdie youre goin to have to help me just a little More Cause did not Know that the pedals had adjustment ?

My iMac has a CD/DVD drive, but I posted a X-Plane 10 pendrive to avoid inserting DVD #1 every session. It functions perfectly. Another point is to connect all peripherals (stick and pedals etc.) BEFORE launching X-Plane 10. Then calibrate your peripherals within XP 10.
I have no pedals set, but instead a pitch-stick with grip throttle and a Logitech joystick with twist grip to fly helicopters.

You are experiencing torque due to the propeller turning faster. You need to apply opposite rudder to compensate.

If the above answer didn't help; there are small silver set-screws on the top and bottom of each pedal. These require a 3mm allen wrench to adjust.


My recommendation is to loosen the bolt until it stops by turning it to the left. This resets them to their loosest setting. There are notches that you'll feel - it is helpful to count the notches so you know how far you have loosened the pedal and allow you to set all the mechanisms to roughly the same release tension. Then turn the wrench to the right more notches than you loosened it. Perform this twice on each pedal and you will have tightened the pedals.

Which model?

Clipping in and out is a learned skill.

That screw in the picture is probably the tension adjuster. Give it a half turn one way or the other but be careful to NOT remove it.

http://www.amazon.com/Pyramid-41451-MTB-CLIPLESS-PEDALS/dp/B000BMT440

Ya you can disable it just go to menu of home page>Controls>assign A command> and disable

I have the same game but what you need to do is go to the menu on the hompage of game and go to controlls and disable it. i will post more details later

Hi,

Have you tried adjusting the sensitivities of each axis using the Control Manager?

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.